Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Regal Rexnord UVANTAGE PLUS
- Page 1 i n s t a l l a t i o n m a n u a l...
- Page 2 Temp Range: 10°C to 60°C Note: Reduced efficacy could occur above 40° C RH Level: 10% to 95% RH UVC LEDs: UL – CCN ABQK, UL 2998, EPA Compliant Regulatory Standards: Safety: UL/ cUL, FCC Part 15 Class B | UVantage PLUS™ Installation Guide...
- Page 3 p r e f e r r e d m o u n t i n g l o c a t i o n s SUPPLY AIR DUCT Optional Location 6” RETURN AIR DUCT Suggested Location For Flex duct, duct board, drywall applications, proposed option of mounting the device at the apex of the evaporator coil Visit UVantage.com for additional information |...
-
Page 4: Safety Guidelines
DO NOT look at the UVC LEDs with naked eyes. UVC radiation is NOT visible to humans. Wavelength is between 200 and 280 nanometers. A Keep out of reach of CHILDREN. A DO NOT touch UVC LEDs with bare hands. | UVantage PLUS™ Installation Guide... - Page 5 I t e m s I n c l u d e d f o r I n s t a l l a t i o n Control Cover Qty 1 Duct Plate Qty 1 LED Module Qty 1 Lead Assembly Qty 1 Screw...
- Page 6 DO’s DON’Ts ✓ Disconnect all power supplies to the ✗ Don’t attempt to look at the HVAC unit and UVantage PLUS™ module UVC LED module while in (hereafter referred to as “LED module”) operation. before beginning any servicing.
- Page 7 i n s t a l l a t i o n 1. Use template to mark the cut-pattern on the duct surface. It is suggested to align the template centered in the ductwork. Ensure there is enough duct depth (minimum 14 inches) before proceeding with the installation.
- Page 8 Recommended mounting torque for the screws is 0.4 ~ 0.5 N-m The direction of the mounting should match the airflow direction in the ductwork as per the marking given on the wall plate. | UVantage PLUS™ Installation Guide...
- Page 9 i n s t a l l a t i o n 4. Connect the wire harness to the LED module and insert the LED module through the hole of the wall plate and rotate it counter-clockwise to lock the LED module.
- Page 10 5. Connect the LED module harness to the control cover as shown in the image. SAFETY SWITCH 6. Snap the control cover firmly to the wall plate. | UVantage PLUS™ Installation Guide...
- Page 11 i n s t a l l a t i o n 7. Connect the 24V adapter plug to the DC jack on the control cover and plug the power supply into an outlet or control wiring depending on the application requirements.
- Page 12 LED turns ON only in the presence of airflow Purple Disinfection OFF / inside the duct. Halted 2. If the UVC LED doesn’t turn on in the presence of airflow, the UVC LED module needs to be replaced. | UVantage PLUS™ Installation Guide...
- Page 13 No UVC Replacement No action required. Notification 100% UVC LED Life consumed. (The UVC LED life Turn off the Uvantage PLUS unit and consult ™ has reached its end supplier for the unit replacement. and replacement is mandatory and...
- Page 14 UVC refers to an ultraviolet light with a wavelength between 200-280 nm. The light in this wavelength can be used for germicidal irradiation in a HVAC system. 2. Where should the UVantage PLUS™ product be installed in the HVAC system? The UVantage PLUS device can be installed safely in all the duct works as highlighted in ™...
- Page 15 T E S T E D A N D E F F E C T I V E Testing conducted by Aerosol Research and Engineering Laboratories, Inc., an independent GLP-compliant lab, indicate UVantage PLUS was effective at reducing 99.99% of T1 and ™...
-
Page 16: Limited Warranty
(photokeratitis). Avoid direct skin exposure to UVC radiation and never look directly into a UVC light source, even briefly. Regal Rexnord and UVantage PLUS are trademarks of Regal Rexnord Corporation or one of its affiliated companies. Regal Rexnord Corporation, Climate Solutions 1946 W. Cook Road, Fort Wayne, IN 46818, United States Designed by Regal Rexnord Corporation.
Need help?
Do you have a question about the UVANTAGE PLUS and is the answer not in the manual?
Questions and answers