Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Satake A710
- Page 1 SATAKE PORTABLE MIXER L 18 ■ ■ ■...
-
Page 2: Table Of Contents
FOREWORD CONTENTS 1. SAFETY CONCERNS ..........................2 2. STANDARD SPECIFICATIONS ......................3 3. CHECK THE FOLLOWING MATTERS....................6 4. PLEASE BE AWARE OF THE FOLLOWING THINGS ................. 7 5. APPEARANCE AND NAMES OF MAIN PARTS ................... 7 6. INSTALLATION ............................. 8 -1. -
Page 3: Safety Concerns
1. SAFETY CONCERNS This label shows that it may cause serious injury or death when you ignore the instruction. This label shows that it may cause harm, or it may cause only physical loss or damage when you ignore the instruction. -
Page 4: Standard Specifications
2. STANDARD SPECIFICATIONS Standard specification of A710, A730, A740... - Page 6 S S tandard dimension table of A710, A730, A740...
-
Page 7: Check The Following Matters
3. CHECK THE FOLLOWING MATTERS Type and size of the standard tools for A710, A730, A740 Power Frame Hex wrench M M odel Width across flat 0.065 A710 10mm A715 A710 0.75 12mm A715 A710 0.06 0.09 A730 10mm 10mm 0.75... -
Page 8: Please Be Aware Of The Following Things
4. PLEASE BE AWARE OF THE FOLLOWING THINGS 5. APPEARANCE AND NAMES OF MAIN PARTS... -
Page 9: Installation
6. INSTALLATION Wear safeguards or protectors (helmet, safety belts, etc.) during installation. Pay attention not to drop the mixer during installation. (Make sure that you have a secure foothold. ) Avoid hand-carry and use a hoist and carts when you move or install the mixer. Do not sling or lift the mixer using handle only. - Page 11 If you tighten the set screws at wrong positions, the shafts may be damaged and not be able to be pulled out. Pay much attention so that powder or mote is not put into the insert hole (for mixing shaft) of drive shaft. In the worst case, the mixing shaft would not be pulled out from drive shaft.
-
Page 12: Mounting Angle And Eccentric Angle
-3. Mounting angle and eccentric angle Left side off-center Right side off-center Mixer Off-center mounting within ±5°from center is prohibited. ... -
Page 13: Preparation For Operating
7. PREPARATION FOR OPERATING -1. Check the body of the mixer... -
Page 14: Check The Liquid Level Position In The Tank
-2. Check the liquid level position in the tank Clamp may get corroded if it is soaked into liquid. Decide the liquid volume considering liquid level rising during mixing. Dimension A710 2.0d or more A730 1.5d or more A740 0.5d or more... -
Page 15: Electrical Wiring
(thermal relay, fuse, non-fuse breaker, etc.) on the power side line. In addition, we recommend you to provide safety devices such as a breaker, ammeter, and emergency stop device to all of your mixers. Wire connection for A710, A730, A740 Model 100V 0.065 0.2kW... -
Page 16: Rotation Direction
-4. Rotation direction 8. OPERATING SUGGESTIONS Never touch the rotating parts during operation. That may cause much damage to your body. Operation that liquid level passes over impeller position and empty operation are forbidden. If you operate the mixer in those ways, the shaft may be bent and the impeller, the mixing shaft, or even the mixing tank may be damaged. - Page 17 ℓ...
-
Page 18: Maintenance And Inspection
Be careful not to turn the switch on carelessly. We recommend you to put a panel showing “Do not supply electric power” around the switch. Bearing list M M odel B B earing A710 0.065 A730 0.06 0.09... -
Page 19: Disassembly
-1. Disassembly... - Page 21 Structural drawing...
- Page 22 A710 A730 A740 Consumable parts list Consumable parts ( Drive shaft, bearing Set screw ) Model Set screw Bear ing...
-
Page 23: Assembly
-2. Assembly... -
Page 24: Troubleshooting
10. TROUBLESHOOTING 1. Shaft deflection C C AUSE D D ETAIL M M EASURES 2. Mixer vibration C C AUSE D D EATAIL M M EASURES... - Page 25 3. Abnormal temperature rising C C AUSE D D ETAIL M M EASURES Abnormal sound CAUSE DETAIL MEASURES Failure to start CAUSE DETAIL MEASURES...
-
Page 26: 11, Storage
11, STORAGE -1. Before unpacking -2. After unpacking... -
Page 27: 12, After-Sale Service And Warranty
12, AFTER-SALE SERVICE AND WARRANTY... -
Page 28: 13, Contact Information
13, CONTACT INFORMATION ■Tokyo Office (Sales Department) ■Osaka Office (Sales Department) ■Chubu Sales Service Center...
Need help?
Do you have a question about the A710 and is the answer not in the manual?
Questions and answers