Do you have a question about the FRPRO LIGHT 5G and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Fracarro FRPRO LIGHT 5G
Page 1
FRPRO LIGHT 5G CENTRALE A CLUSTER PROGRAMMABILE PROGRAMMABLE CLUSTER HEADEND STATION DE FILRAGE PROGRAMMABLE Istruzioni di impiego Operating instructions Mode d’emploi...
In caso di guasto non tentate di riparare il prodotto altrimenti la garanzia non sarà più valida. Le informazioni riportate in questo manuale sono state compilate con cura, tuttavia Fracarro Radioindustrie S.r.l. si riserva il diritto di apportare in ogni momento e senza preavviso, miglioramenti e/o modifiche ai prodotti descritti nel presente manuale.
DESCRIZIONE DEL PRODOTTO La centrale Fracarro FRPRO LIGHT 5G è una centrale compatta programmabile ad alta selettività in grado di filtrare, convertire e amplificare i multiplex (mux) digitali in banda FM, VHF e UHF e miscelarli in uscita. La centrale è un processore “Flessibile” di canali Digitali Terrestri e può essere utilizzata per gestire i segnali in impianti piccoli, medi o anche in grandi installazioni come quelle Hospitality.
Page 4
PROGRAMMAZIONE MANUALE DEGLI INGRESSI Selezionare INGRESSO FM/V/U 1 per iniziare ad impostare il primo ingresso. ► L’amplificatore interno è già attivo per impostazione di fabbrica, se il segnale in ingresso supera gli 80 ► dBμV si consiglia di disattivare la funzione PRE-AMPLI. Se dovesse essere necessario utilizzare dei preamplificatori da palo, impostare la tele alimentazione nelle ►...
OFF -> il più debole dei 2 segnali sarà rifiutato. La funzione SELF EQUALIZ permette di gestire la scansione automatica dei mux, in questo caso se ► imposto su: ON -> Nel caso di interruzione dell’alimentazione per un breve tempo (da 0 a 5 secondi), verrà eseguita una nuova scansione automatica, se l’interruzione è...
I dati tecnici sono nominali e riferiti alla temperatura di 25 °C e potrebbero variare senza preavviso. CONFORMITA’ ALLE DIRETTIVE EUROPEE Fracarro dichiara che il prodotto è conforme alle direttive 2014/53/UE e 2011/65/UE. Il testo completo della dichiarazione di conformità UE è disponibile al seguente indirizzo internet ce.fracarro.com.
The product must only be installed by qualified persons, according to the local safety standards and regulations. Fracarro Radioindustrie is free from all civil and criminal responsibilities due to breaches of the current legislation derived from the improper use of the product by the installer, user or third parties. The product must be used in full compliance with the instructions given in this manual in order to protect the operator against all possible injuries and the product from being damaged.
▼ Power up the FRPRO LIGHT 5G headend; the device initializes in a few seconds. The programming of the FRPRO LIGHT 5G headend can be carried out using the display and the keys on the front of the device. ▼...
Page 10
MANUAL INPUT CONFIGURATION ▼ Select INPUT FM/V/U1 to start setting the first input. ▼ The internal amplifier is already active by factory setting, if the input signal exceeds 80 dBµV it is recommended to disable the PRE-AMPLI function. ▼ Should it be necessary to use mast preamplifiers, set the remote power supply in the advanced settings (12V o 24V) and enable the DC parameter.
OFF -> the weaker of the 2 signals will be eliminated. The SELF EQUALIZ function allows you to manage the automatic mux scan, in this case if set to: ► ON -> In case of power off for a short time (from 0 to 5 seconds), the device have a new automatic scan, if the interruption is longer, no changes will be made.
The technical data are nominal and refer to a temperature of 25 ° C and could change without notice. CONFORMITY TO EUROPEAN LAWS Fracarro declares that the product complies with EU Directive 2014/53 and 2011/65/UE. The full text of the EU Declaration of Conformity is available on the following website ce.fracarro.com.
L’installation du produit doit être effectuée par du personnel qualifié conformément aux lois et aux normes locales sur la sécurité. Par conséquent, Fracarro Radioindustrie décline toute responsabilité civile ou pénale dérivant de violations des normes juridiques en vigueur et de l’utilisation incorrecte du produit de la part de l’installateur, de l’utilisateur ou de tiers.
DESCRIPTION DU PRODUIT La station Fracarro FRPRO EVO 5G est une station compacte programmable à haute sélectivité en mesure de filtrer, amplifier et convertir les canaux numériques dans les bandes FM, VHF et UHF. La station FRPRO LIGHT 5G est un processeur flexible de canaux numériques terrestres et peut être utilisée pour réaliser des installations de distribution de moyennes et grandes dimensions.
Page 16
PROGRAMMATION MANUELLE DES ENTREES Sélectionnez ENTREE FM/V/U 1 pour paramétrer la première entrée. ► Le pré-amplificateur interne est activé par défaut, si le signal d'entrée dépasse le 80dBµV il est conseillé de ► désactiver la fonction PRE-AMPLI. Si des pré-amplificateurs de mât sont présents paramétrez la valeur de la tension d’alimentation (12 ou ►...
Page 17
OFF -> le plus faible des deux signaux sera refusè. La fonction AUTO-EGALIS permet de gérer la recherche automatique des mux: ► ● ON -> Dans le cas d'une courte interruption de l'alimentation (de 0 à 5 secondes), la station réalise une nouvelle recherche automatique, si l'interruption est dure plus longtemps il n'y aura aucune modification.
Page 20
CONFORMITÉ AUX DIRECTIVES EUROPÉENNES Fracarro déclare que le produit est conforme aux directives 2014/53/UE et 2011/65/UE. Le texte intégral de la déclaration de conformité UE est disponible à l’adresse internet suivante ce.fracarro.com INFORMATION AUX UTILISATEURS Traitement des appareils électriques et électroniques en fin de vie (Applicable dans les pays de l'Union Européenne et aux autres pays européens disposant de systèmes de collecte sélective)
Need help?
Do you have a question about the FRPRO LIGHT 5G and is the answer not in the manual?
Questions and answers