Advertisement
120V Circuit Requirements
This tool is prewired to operate on a power supply
circuit that has a verified ground and meets the
following requirements:
Nominal Voltage .................... 110V, 115V, 120V
Cycle ..........................................................60 Hz
Phase ........................................... Single-Phase
Power Supply Circuit ......................... 15 Amps
Plug/Receptacle ............................. NEMA 5-15
Grounding & Plug Requirements
This tool MUST be grounded. In the event of
certain malfunctions or breakdowns, grounding
reduces the risk of electric shock by providing a
path of least resistance for electric current.
This tool is equipped with a power cord that has
an equipment-grounding wire and a grounding
plug. Only insert plug into a matching receptacle
(outlet) that is properly installed and grounded in
accordance with all local codes and ordinances.
DO NOT modify the provided plug!
GROUNDED
5-15 RECEPTACLE
Grounding Pin
5-15 PLUG
Neutral Hot
Figure 10. Typical 5-15 plug and receptacle.
SHOCK HAZARD!
Two-prong outlets do not meet the grounding
requirements for this tool. Do not modify or
use an adapter on the plug provided—if
it will not fit the outlet, have a qualified
electrician install the proper outlet with a
verified ground.
-4-
Operation
Press the ON/OFF button shown in Figure 11
once to turn the LED light ON; press the button
again to turn the light OFF.
Figure 11. Location of ON/OFF button.
Apply light pressure at each of the articulating
joints to manuever the light to the desired position.
To rotate the light from side to side, loosen the
cap screws shown in Figure 12, rotate the light
to the desired position, then tighten the screws to
secure.
x 2
Figure 12. Location of cap screws in base.
Model T33679 (Mfd. Since 3/23)
ON/OFF
Button
Advertisement
