Philips NORELCO 7000 Series Manual page 4

- Discharge the battery completely twice a
year by letting the motor run until it stops.
- Do not keep plug permanently plugged in.
Operating time
When the product is fully charged, it has a
cordless operating time of up to 50 minutes.
Using the product
- Use this product for its intended household
use as described in this manual.
- For hygienic reasons, the product should
only be used by one person.
Note: This product is for cordless use only.
Switching the product on and off
Shaver
1 Press the shaving on/off button once to
switch the product on or off (Fig. 6).
Trimmer
1 Press the trimming on/off button once to
switch the product on or off (Fig. 7).
Attaching and detaching the combs
Attaching the comb
1 Slide the beard or body comb into the
guiding grooves on both sides of the
handle.
2 Press the length selector and then slide it
up or down to select the desired hair length
setting (Fig. 8).
Detaching the comb
1 Press the length selector and then slide the
comb upwards off the product.
Trimming length settings
The trimming combs allow you to cut hair to 5
different lengths:
Hair length
setting
1
2
3
4
5
Trimming
- If you are trimming for the first time, be
careful. Do not move the product too fast.
Make smooth and gentle movements.
- When you trim for the first time, start at the
highest length setting to familiarize
yourself with the product.
- Since all hairs do not grow in the same
direction, you may want to try different
trimming positions (i.e. upwards,
downwards, or across). Practice is best for
optimum results.
- Always make smooth and gentle
movements and be sure the surface of the
comb always stays in contact with your skin.
- For body trimming, make sure hair is clean
and dry as wet hair tends to stick to the
body and, when trimming sensitive areas,
always use the body comb.
1 Hold the product in the trimming position,
with the trimming unit pointing upwards
and the shaving unit pointing downwards
(Fig. 9).
2 Slide the beard or body comb into the
guiding grooves on both sides of the
handle.
3 Press the length selector and then slide it
up or down to select the desired hair length
setting (Fig. 10).
- The two lines next to the setting selector
show which setting you have selected
(Fig. 11).
4 Switch on the product (Fig. 7).
5 Hold product as shown and move the
trimmer against the direction of hair
growth making sure the tips of the comb
point in the same direction as you are
moving the product (Fig. 12).
6 Switch off and clean the product after each
use (see 'Cleaning').
Shaving
Do not use this shaving unit to shave or
trim facial or scalp hair (Fig. 15). The
shaving unit should only be used on skin
below the neckline.
- When shaving sensitive areas for the first
time, you may feel some discomfort,
irritation or reddening of the skin. This is
normal as your skin needs time to adjust to
shaving.
Hair length after
trimming
1/8 in. / 3 mm
3/16 in. / 5 mm
9/32 in. / 7 mm
3/8 in. / 9 mm
7/16 in. / 11 mm