Safety Rail Source Kee Dome Information Sheet

S E P A R A T I N G P E O P L E
Technical Information Sheet
Kee Dome
Kee Dome® is a collective, free-standing, fall
protection system specifically designed for use
around skylights.
Kee Dome is formed of continuous rails with no
breaks or access points. Specific versions may be
available if access points are required.
Kee Dome® utilizes standard Kee Klamp®
components and proprietary
baseplates at each corner of the square skylight to
eliminate slippage.
Kee Dome® OSHA: Regulation 29 CFR 1910.23 (e)
(1) ; (e) (3) (iv), OSHA Regulation 29 CFR 1926.502
(b) (1) - (b) (14), all applicable state, local and
regional codes and with a design load of 200lbs.
applied in any direction at any point on the top rail.
Rails and Posts: Pipe: ASTM A153 1-1/2 inch,
galvanized
Kee Klamp fittings: Elbows, Crossovers, Wall
flanges, Tees, Couplings, galvanized.
The maximum skylight size is 6'6" (2m) x 6'6" (2m)
for the standard KDH Model. Larger sizes may be
available.
Kee Dome® is suitable for use on any roof type, but
must not be used on a pitched roof greater than
3°.
At full extension, the standard KDH system weighs
approximately 165lbs. (75kg). Check the safe
weight load for the roof before installing.
F R O M H A Z A R D S
recycled PVC
ASSEMBLY INSTRUCTIONS FOR STANDARD KEE DOME
MODEL KDH.
Before assembly / installation, check the roof area concerned
is free from the following:
Snow; ice; lubricants; loose substances or; any obstructions
that would prevent installation of the bases. Check if P.P.E.
and temporary anchor point is required for the duration of the
installation.
1. Position the feet at the corners (right against the corner of
2. Position the clamping ring into the slot of each base
3. Drop a pre-assembled upright into each base
4. Measure the required length for each rail
5. Cut rails and assemble
6. Make sure bases are still against the skylight / curb.
7. Tighten all grub-screws to 29ft. /lbs. (39Nm).
the dome skylight).
(ensuring the grub-screw is accessible).
Safety Rail Source
2570 Blvd of the Generals
Suite 200
Norristown, PA 19403
(877) 723 3766
www.safetyrailsource.com
info@safetyrailsource.com