CHANGING THE BATTERY
When the indicator goes dim or no longer lights
while an effect is on, it means that the battery is
nearly dead and must be replaced.
Thumbscrew
7
P g Coil Spring
Guide
Bush
Hole
Housing
9V Battery
10
FREQUENCY RESPONSE
+15
Ke
. Loosen the thumbscrew at the front of the
pedal, then lift the pedal upwards to open the
unit.
* The thumbscrew can be left in the pedal
while changing the battery.
. Remove the old battery from the battery
housing, and remove the snap cord con-
nected to it.
3. Connect the snap cord to the new battery, and
place the battery inside the battery housing.
* Be sure to carefully observe the battery+s
polarity (+ versus -).
4. Slip the coil spring onto the spring base on the
back of the pedal, then close the pedal.
* Carefully avoid getting the snap cord caught
in the coil spring.
`
5. Finally, insert the thumbscrew into the guide
bush hole and fasten it securely.
1k
10k
FREQUENCY(Hz)
11