CUBETAPE C200 Series Quick Start Manual

SET UNITS AND OUTPUTS
Select preferred units and outputs.
Units= mm and Output 0.1 for model C200S only.
Unit mm Unit cm Unit in
Output 0.1 Output 0.25 Output 0.5
Output Nearest 1 Output Next 1
SET SUFFIX
Select preferred suffix for use with
Dimensional (DIM) and General (GEN) items.
Suffix Dim CR Suffix Dim TAB
Suffix Gen CR Suffix Gen TAB
Additional suffixes and prefixes available at
www.cubetape.com/support
REFERENCES AND RESOURCES
ScanStik Shortcuts
User Guide
Charge Cradle also contains the Shortcuts Code
on base.
For Scan to Pair and NFC pairing options go to
Configuration Guide.
For full manual go to
www.cubetape.com/support
For support email
support@cubetape.com
DEFAULTS AND FACTORY RESET
Factory default settings are:
Connect to Windows host using dongle.
Sleep time 10 minutes.
Units = inches
Output = nearest inch
Suffix DIM = TAB
Suffix GEN = TAB
Return to factory settings anytime by scanning
Scanner Defaults V2 and Wireless Defaults.
Scanner Defaults V2 Wireless Defaults
C200 Series
Quickstart Guide
IN THE BOX
C200
USB Cable RF Dongle
C200 Series
Quickstart Guide
IN THE BOX
C200
USB Cable RF Dongle Charge Cradle
(if selected)
Bigfoot
Silicone Tip Quickstart Guide ScanStik
Scan Registration QR code or visit
Bigfoot www.cubetape.com/register to register your device
Silicone Tip Quickstart Guide
Scan Registration QR code or visit
to register your device.
www.cubetape.com/register
Charge Cradle
(if selected)
ScanStik