Advertisement
Set up your remote to operate other brand name devices
Turn on the device you want to program.
On the chart on page 49/50,
find the type of device you're
programming,
and then find the brand name. Make a note of
the three-number
code,
you'll
need it soon.
Press and how PRG. It's recessed so it doesn't get pushed
accidentally.
Use a smart, blunt object.
When the indicator
tight turns on, you can release PRG.
Push the key name with the type of device you're program-
ming (VCR, CABLE, AUX, TV).
Using the NUMBER keypad, enter the three-number
code you
found on page 49/50.
PressENTER to save the code. (The indicator tight wilt flash
3 times, then turn off to indicate the code is valid.)
Point the remote at the device and push POWER.It should
turn off. If not, try the other codes listed and continue from
step three.
Note: To reset remote to factory settings, enter 9-1-1, in
Step 5.
Programming your Zenith remote may allow you to use one remote
to work up to 7 different
devices, ij: aU modes are programmed.
Not aU devices wilt work with your Zenith remote control.
Mode / Product Compatibitity
TV
VCR
CATV
AUX (AUX+t, AUX+2, AUX+3)
TVs VCRs Cable Boxes,
ALLproducts on pp 49 - 50
Satellite Receivers
PROGRAMMING
Procedureto set up remote to operate other equipment.
PRG
Programming mode key.
DEVICE
Infra-red remote control[able electronic accessoryequipment.
2o6-_4
PA G E 4 5
Advertisement
