Advertisement
BP-FN11/12 & MX-PN14B
Finisher Lab
OBJECTIVES
At the completion of this exercise, you will be able to remove the Finisher and Punch Units,
perform a Component ID, and review the necessary adjustments to ensure each unit's
optimal performance.
Note: Each procedure starts on a new page. Continue until all procedures have been
completed.
RESOURCES
BP-FN11/12 Service Manual
•
BP-50/70 Service Manual, Chapter 6
•
BP-50/70 Installation Manual, Chapter 7 and 8
•
Procedure 1: Testing components and sensors on the Finisher
Reference Guides:
In the BP-FN11/12 Service manual, find the "Exteriors" diagrams and "Internal
•
mechanism" diagrams.
In the BP70C45 Service Manual, go to the "Details of Simulations" section.
•
Perform the following:
1. Remove the front cover of the Finisher and, by cheating the door switch, watch the
operation of the unit running in Non-Staple, Staple, and Pamphlet Mode.
2. Perform Simulations 3-2 and 3-3 to check Sensors and Components.
Service Success Center: https://service.sharpamericas.com/
Sharp Academy: https://satech.sharpamericas.com/Sharp-Academy
Questions? Contact us at success@sharpsec.com
Page 1
Advertisement
Table of Contents
Related Manuals for Sharp BP-FN11
Summary of Contents for Sharp BP-FN11
- Page 1 BP-50/70 Installation Manual, Chapter 7 and 8 • Procedure 1: Testing components and sensors on the Finisher Reference Guides: In the BP-FN11/12 Service manual, find the “Exteriors” diagrams and “Internal • mechanism” diagrams. In the BP70C45 Service Manual, go to the “Details of Simulations” section.
- Page 2 1. Remove the Finisher from the Main Unit. 2. Remove the Rear Cover. 3. Perform Component ID and note the differences between the BP-FN11 and the BP- FN12. 4. Remove the Stapler unit. 5. Reinstall the Stapler unit.
- Page 3 ADJ 1 - Punch PWB Destination Setting • ADJ 2 - Punch Position Adjustment • Congratulations! You have completed this exercise. Return to your seat for review. Page 3 Service Success Center: https://service.sharpamericas.com/ Sharp Academy: https://satech.sharpamericas.com/Sharp-Academy Questions? Contact us at success@sharpsec.com...
Need help?
Do you have a question about the BP-FN11 and is the answer not in the manual?
Questions and answers