Table of Contents
Advertisement
5.5
COVER INTERLOCK MAGNET
The cover interlock magnet, item 3 of Figure 5-1, is located underneath
the left side of the top cover.
To replace the magnet, refer to Figure 5-1 and
perform the following steps:
1.
Place the clear hinged portion of the top cover in the open
position.
2.
Place a small amount of adhesive onto one side of the magnet (3)
to be installed.
3.
Place the magnet into the slot on the cover and hold in place
until dry.
5.6
RIBBON CASSETTE AND GUIDE
The ribbon cassette is mounted to the left and right side frames and
the ribbon guide is mounted over the front of the print head.
No tools are
required to remove the cassette and guide.
To remove the cassette and guide,
refer to Figure 5-2 and perform the following steps:
1.
Remove the top cover from the printer per paragraph 5.4.
2.
Unsnap the top of the rear cover and place in the open position.
3.
Ensure the print head is at the extreme left margin.
4.
Place the forms lever in the "LOAD" position.
5.
Lift the column scale into the up position.
6.
Pull the
h~ad
adjustment lever back to its maximum position.
7.
Remove the ribbon guide from the front of the print head by
squeezing together the two tabs at the top of the ribbon guide
and lifting upward.
8.
Lift the used ribbon cassette and guide (1) up and out of the
printer.
9.
To install the new ribbon cassette and guide, reverse steps 1
through 8.
5.7
PRINT HEAD ASSEMBLY
The print head assembly, item 2 of Figure 5-2, attaches to the carriage
and no tools are required to remove the print head.
To remove the print head,
refer to Figure 5-2 and perfrom the following steps:
1.
Remove the top cover from the printer.
2.
Unsnap the top of the rear cover and place in the open position.
5-4
Advertisement
Table of Contents
