Table of Contents
Advertisement
VHFAUHF
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on Recording VCR. To
monitor the dubbing, also connect a TV as shown.
©
Connect AUDIO OUT terminal on Playing VCR to AUDIO IN terminal on Recording VCR.
in place of a Playing VCR, you can use other equipment, such as a Camcoder.
Simply connect the unit's Audio/Video outputs to the Recording VCR.
Playing (Source) VCR
Recording (Editing) VCR
1
Insert pre-recorded tape.
2
Press PLAY, then PAUSE/SLOW
3
immediately to enter PLAY/PAUSE mode.
The operation of steps 4 and 5 must be done on both
playing and recording VCRs at the same time.
Press PLAY to start dubbing.
Playing VCR starts playback.
5
Press STOP to stop dubbing.
ll To Monitor Dubbing on Your TV
1 Tum your TV on and tune to the Recording
YCR channel (CH3
or CHA).
2 Set the VCR/ TV Selector on the Recording
VCR to "VCR."
Dubbing tapes protected with Copy Guard will
have poor quality results.
Insert blank tape with record tab.
Press INPUT to set VCR Input mode to LINE for
Video Input. (See "Selecting the Input Mode"
below.)
Press REC, then PAUSE/SLOW
immediately to enter REC/PAUSE mode.
Press PAUSE/SLOW to start dubbing.
Recording VCR starts recording.
Press STOP to stop dubbing.
li Seiectingnput Mode
Method 1,
-->press INPUT to switch between channel number and
LINE.
Method2,
-->press CH À / V to change display as follows.
j—2—3
|
(CABLE)
(TV)
|
LINE4——»125
or
69
* "L" lights about 4 sec. on front panel when LINE is
selected.
Caution: Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproductsé panasonic.com
Advertisement
Table of Contents
