ASROCK AMD A620A Series Setup Manual page 61

AMD X670/B650/A620/A620A Series
MBIST Test Mode
Allows you to select MBIST Test Mode - Interface Mode (Tests Single and Multiple CS
transactions and Basic Connectivity) or Data Eye Mode (Measure Volage vs. Timing).
Configuration options: [Auto] [Interface Mode] [Data Eye Mode] [Both]
MBIST Aggressors
Allows you to enable or disable MBIST aggressor test.
Configuration options: [Auto] [Disabled] [Enabled]
MBIST Per Bit Slave Die Reporting
When it is enabled, it reports 2D Data Eye Results in ABL Log for each DQ, Chipselect and
Channel.
Configuration options: [Auto] [Disabled] [Enabled]
DDR Data Eye
Press [Enter] to configure DDR Data Eye options.
Pattern Select
Allows you to configure Pattern Select.
Configuration options: [PRBS] [SSO] [Both]
Pattern Length
This token helps to determine the pattern length. The possible options are N=3...12.
Aggressor Channel
This helps to read the aggressors channels. If it is enabled, you can read from one or more
than one aggressor channel.
Configuration options: [Disabled] [1 Aggressor Channel] [3 Aggressor Channels] [7
Aggressor Channels]
DDR Memory Features
Press [Enter] to configure DDR Memory Features.
Memory Context Restore
Allows you to configure the mermoy context restore mode. When it is enabled, DRAM re-
retaining is avoided if possible and the POST latency is minimized.
Configuration options: [Auto] [Disabled] [Enabled]
NBIO Common Options
Press [Enter] to configure NBIO Common options.
IOMMU
Allows you to enable or disable IOMMU.
Configuration options: [Auto] [Disabled] [Enabled]
57