Download Print this page

Viking DM-4 Technical Practice page 2

Digit monitor

Advertisement

"T" Adapter
(included)
A. Mode Descriptions
Mode
Description
Drops the oldest digit from the display as a new Touch Tone digit is received (only on display overflow).
dr09
The only digits displayed are Touch Tones 0 - 9.
Drops the oldest digit from the display as a new Touch Tone digit is received (only on display overflow).
drEC
All Touch Tone characters are displayed (0 - 9, Q, #, A, B, C, D).
Rolls the digits onto the display if they overflow the display (14 digits maximum).
ro09
The only digits displayed are Touch Tones 0 - 9.
Rolls the digits onto the display if they overflow the display (14 digits maximum).
roEC
All Touch Tone digits are displayed (0 - 9, Q, #, A, B, C, D).
B. Changing the Mode
1. Press and hold the MODE SELECT/RESET button until the current mode is displayed, then release.
2. Momentarily press the MODE SELECT/RESET button to change the DM-4 from the current mode to the next.
3. When the desired operational mode has been selected, The DM-4 will continue to display that operational mode
for approximately 3 seconds.
4. Save your selection and return to normal operation.
C. Display
The DM-4 can be programmed to display all Touch Tone characters or only
numeric digits. If the mode is selected to show all characters, they will be
displayed as shown in the chart to the right.
The display will be cleared by any of the following:
1. Momentarily pressing the MODE SELECT/RESET button.
2. An "On-Hook" signal of a telephone or device connected to the same line as the
DM-4.
3. If more than 20 seconds elapse between Touch Tone entries, the display will
automatically blank on the next incoming Touch Tone.
The DM-4 continuously monitors for Touch Tones and displays them on a four-digit display in one of four operational
modes. The DM-4 can display both numeric digits and extended DTMF characters.
Product Support Line...(715) 386-8666
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking
Electronics, its affiliates and/or subsidiaries assume no responsibility for errors and/or omissions contained in this information. Revisions of
this document or new editions of it may be issued to incorporate such changes.
Fax Back Doc # 205
Installation
VIKING
MODEL DM-4
DIGIT MONITOR
MODE SELECT/RESET
DROP OFF DIGITS,
NUMBERS ONLY
DROP OFF DIGITS,
EVERY CHARACTER
ROLL OFF DIGITS,
NUMBERS ONLY
ROLL OFF DIGITS,
Telephone
EVERY CHARACTER
Programming
Operation
Printed in the U.S.A.
©
Fax Back Line...(715) 386-4345
120V AC
Character
Display
Q
#
A
B
C
D
ZF290540 Rev B

Advertisement

loading