Hitachi VM-8480LE Service Manual page 85

¥*3-24, Reel Gear Block, Mechanism State Switch and
2) Disconnct 1 connector (1) on the mechanism SHH
state switch
3) Remove 1 screw (2) holding the mechanism state
switch.
4) Remove the mechanism state switch.
5) Remove the relay gear.
6) Remove 4 screws (3) holding the reel gear
block.
7) Remove the reel gear block. CAPSTAN
Caution when reinstalling
1) Reinstall the loading gear so its mark (c) and
mark (D) on the supply loading cam gear are
aligned. (See Fig. 3-32)
2) Reinstall the tension pole drive arm so that
hole (E) in this arm is aligned with hole (F)
in the driving gear.
3) Align section (A) of the mechanism state
switch and mark (B) of the rotor.
(See Fig. 3-31)
4) Align hole (G) in the driving gear and mark (H)
on the relay gear. Check that hole (I) in the
relay gear in aligned with the hole in reel
gear block. (See Fig. 3-32)
5) Install the mechanism state switch in
condition set in step 3) in to the chassis,
Fig. 3-30
SUPPLY LOADING
CAM GEAR
MARK (D}
TAKE-UP
LOADING
CAM GEAR
MARK (C)
MECHANISM
LOADING
STATE
aie
GEAR
TENSION
POLE
DRIVE ARM
DRIVING
GEAR
ROTOR
MARK (8)
:
MECHANISM
STATE
MARK (H} SWITCH
(A)
RELAY
y
GEAR
REEL GEAR BLOCK
(BOTTOM VIEW)
(TOP VIEW)
Fig.3-31
aC
El - 14