Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Case SPX Series
- Page 1 SPX Series Patriot Sprayer SPX 4260 Troubleshooting Manual 86986705...
- Page 2 It is your responsibility to observe pertinent laws and regulations and follow Case Cor poration instructions on machine operation and maintenance. © 2003 Case, LLC 86986705 Issued February 2003 CASE and IH are registered trade marks of Case, LLC Find manuals at https://best-manuals.com...
- Page 3 CASE IH TECHNICAL MANUALS Manuals are available from your Dealer for the operation, service and repair of your machine. For prompt, convenient service, contact your Dealer for assistance in obtaining the manuals for your machine. Your Dealer can expedite your order for operator’s manuals, parts catalogs, service manuals and maintenance records.
- Page 4 CONTROLLER SYSTEMS ..........8000 SPX 4260 REQUIRED AND RECOMMENDED TOOL LIST ..... . 9000 CASE IH APPLICATION EQUIPMENT 260 Highway 12 SE Benson, MN 56215 U.S.A...
- Page 5 Find manuals at https://best-manuals.com...
- Page 6 Section 1000 STANDARD TORQUE SPECIFICATIONS LOCTITE PRODUCT CHART Case IH Application Equipment 260 Highway 12 SE Benson, MN 56215 © 2003 Case, LLC SPX 4260 Troubleshooting Manual Issued 2-03 Printed in U.S.A. Standard Torque Specifications And Loctite Product Chart Find manuals at https://best-manuals.com...
- Page 7 Find manuals at https://best-manuals.com...
-
Page 8: Table Of Contents
O-Ring Boss End Fitting or Lock Nut ........7 NOTE: Case, LLC reserves the right to make improvements in design or changes in specifications at any time without incurring any obliga- tion to install them on units previously sold. -
Page 9: Torque Specifications - Decimal Hardware
1000 - 4 TORQUE SPECIFICATIONS - DECIMAL HARDWARE Use the torques in this chart when special torques are not given. These torques apply to fasteners with both UNC and UNF threads as received from suppliers dry, or when lubricated with engine oil. Not applicable if special graphites, Molydisulfide greases, or other extreme pressure lubricants are used. -
Page 10: Torque Specifications - Metric Hardware
1000 - 5 TORQUE SPECIFICATIONS - METRIC HARDWARE Use the following torques when specifications are not given. These values apply to fasteners with coarse threads as received from supplier, plated or unplated or when lubricated with engine oil. These values do not apply if graphite, Molydisulfide greases, or oil is used. Grade 8.8 Bolts, Nuts, and Studs Grade 10.9 Bolts, Nuts and Studs 10.9... -
Page 11: Torque Specifications - Steel Hydraulic Fittings
1000 - 6 TORQUE SPECIFICATIONS - STEEL HYDRAULIC FITTINGS 37 Degree Flare Fitting Straight Threads with O-Ring Tube OD Thread Pound- Newton Tube OD Thread Pound- Newton Hose ID Size Inches Metres Hose ID Size Inches Metres 1/4 inch 7/16-20 72 to 144 8 to 16 1/4 inch... -
Page 12: Torque Specifications - Steel Hydraulic Fittings
190 to 200 258 to 271 38.1 mm NOTE: Case, LLC reserves the right to make improvements in design or changes in specifications at any time without incurring any obligation to install them on units previously sold. SPX 4260 Troubleshooting Manual Issued 2-03 Printed in U.S.A. - Page 13 1000 - 8 SPX 4260 Troubleshooting Manual Issued 02-03 Printed in U.S.A. Standard Torque Specifications And Loctite Product Chart...
- Page 14 1000 - 9 SPX 4260 Troubleshooting Manual Issued 2-03 Printed in U.S.A. Standard Torque Specifications And Loctite Product Chart...
- Page 16 Section 1001 SAFETY CASE IH APPLICATION EQUIPMENT 260 Highway 12 SE Benson, MN 56215 U.S.A © 2003 Case, LLC SPX 4260 Troubleshooting Manual Issued 2-03 Printed in U.S.A. Safety...
- Page 18 SAFETY ..............4 NOTE: Case, LLC reserves the right to make improvements in design or changes in specifications at any time without incurring any obliga- tion to install them on units previously sold.
- Page 19 DO NOT DO NOT REMOVE OPERATE THIS TAB! See Other Side Reason Case Part No. Printed in Signed by U.S.A. WARNING: Read the Operators Manual to familiarize yourself with the correct control functions. WARNING: Operate the machine and equipment controls from the seat position only. Any other method could result in serious injury.
- Page 20 1001 - 5 WARNING: When working in the area of the fan belt with the engine running, avoid loose clothing if possible, and use extreme caution. WARNING: When doing checks and tests on the equipment hydraulics, follow the procedures as they are written. DO NOT change the procedure. WARNING: When putting the hydraulic cylinders on this machine through the necessary cycles to check operation or to remove air from a circuit, make sure all people are out of the way.
- Page 21 1001 - 6 WARNING: When the battery electrolyte is frozen, the battery can explode if (1), you try to charge the battery, or (2), you try to jump start and run the engine. To prevent the battery electrolyte from freezing, try to keep the battery at full charge. If you do not follow these instructions, you or others in the area can be injured.
- Page 22 Section 1002 GENERAL INFORMATION AND SPECIFICATIONS CASE IH APPLICATION EQUIPMENT 260 Highway 12 SE Benson, MN 56215 U.S.A © 2003 Case, LLC SPX 4260 Troubleshooting Manual Issued 2-03 Printed in U.S.A. General Information And Specifications...
- Page 24 SPECIFICATIONS ............5 NOTE: Case, LLC reserves the right to make improvements in design or changes in specifications at any time without incurring any obliga- tion to install them on units previously sold.
- Page 25 Replace shafts as necessary. Service Parts Always install genuine Case service parts. When ordering refer to the Parts Catalog for the correct part number of genuine Case replacement items. Failures due to the use of other than genuine Case replacement parts are not covered by warranty.
- Page 26 1002 - 5 SPECIFICATIONS Item Specification Engine CDC 6TA-830, 260 hp turbo charged and after cooled diesel Drive Hydrostatic with full-time, 4-wheel drive. Infinitely variable shifting returns the wheel motor to maximum torque each time the hydrostatic control lever is returned to neu- tral.
- Page 27 1002 - 6 Item Specification Sprayer Control Raven, Mid-Tech or Optional Dickey-john Land Manager Product Pump Centrifugal pump, hydraulic motor driven with electric cab control Foam Marker 60 gal / 152 liters Rinse Tank 70 gal / 266 liters Hydraulic Tank 25 gal / 94.6 liters Capacity Coolant Capacity...
- Page 28 Section 1003 MAINTENANCE CASE IH APPLICATION EQUIPMENT 260 Highway 12 SE Benson, MN 56215 U.S.A © 2003 Case, LLC SPX 4260 Troubleshooting Manual Issued 2-03 Printed in U.S.A. Maintenence...
- Page 30 1003 - 3 TABLE OF CONTENTS LUBRICATION AND MAINTENANCE ......... .5 Proper Disposal Of Materials .
- Page 31 This as a preview PDF file from best-manuals.com Download full PDF manual at best-manuals.com...
Need help?
Do you have a question about the SPX Series and is the answer not in the manual?
Questions and answers