Download Print this page
Delta Rockwell 22-101 Manual

Delta Rockwell 22-101 Manual

13" x 5" planer

Advertisement

Quick Links

DELTA POWER TOOL DIVISION
RC>~KVVELL
MANUFACTURING
COMPANY
PITTSBURGH
8.
PENNSYLVANIA
~
I
I
ROC
Ell
428-01-651-5001
DATED
1M
1-10-61
PM-1738
13"
x
5" PLANER
MODEL
#
22-101
SERIAL #
Dy3675
I. INSTALLATION
A. SELECTING FLOOR SPACE
The planer should be placed with adequate room
both in front and back for dressing long stock.
It
should
set on a level foundation and can be bolted permanently
in place if preferred.
If
a central dust collecting system is accessible,
it can be connected to the planer by installing
1t22-115
shaving hood. This hood and other accessories are
available from your Delta dealer.
IMPORTANT
We urge you to read these instructions carefully
and save them for future reference. When ordering re-
placement parts from your Delta dealer, always furnish
part number, description, model number and serial num-
ber of your machine.
B. REMOVING PROTECTIVE COATING
Remove protective coating from machined surfaces
using kerosene or similar solvent. Do not use lacquer
thinner or acetone.
C. INSTALLING MOTOR FIG. 2.
1.
Place motor pulley on shaft, approximately 1/16"
from end of motor and tighten set screw. Remove
rear panel from planer base and bolt motor to
motor plate.
~
2. Remove plate on right hand side of planer and
align motor pulley and cutterhead pulley. Use a
narrow straight edge or string, and slide motor to
the right or left so that both pulleys are in line.
3. Tighten set collars on tie rod and install "V"
belt. Motor can be adjusted up or down by turning
nuts on "I" bolts to appJ..y correct belt tension.
Belt should only be tight enough so that it can be
"flexed" approximately 1", applying finger pres-
sure midway between the pulleys. Tighten both
nuts against motor plate.
Tighten screw and locknut ( 15 ) ( 45 ) under-
neath rear tie rod. See FIG. 22 of parts list.
D. ELECTRICAL CONNECTIONS
When using magnetic starters, Delta No. 49-393,
49-394
or 49-395, a special cover plate, Delta No.
49-376 is required. This cover plate includes the neces-
sary installation instructions.
When using Manual starters, Delta No. 1320 or
1328, See Fig. 3, and:
1.
Remove cast iron cover on left side of planer.
2. Delta starters are enclosed in a steel box. The
starter mechanism must be removed from this box
and installed in planer as shown using three
10-32 x
lh"
Rd. Rd. Machine screws furnished
with planer.
3. Install proper heater elements, connect starter to
motor and replace cast iron cover.
Figure 2

Advertisement

loading
Need help?

Need help?

Do you have a question about the 22-101 and is the answer not in the manual?

Questions and answers