Table of Contents
Advertisement
Pick-up Height
1) Worn or damaged cams or levers.
Inspect for worn or damaged parts. Replace and
lubricate as required.
a) Arm does not lift
of record on return
cycle:
2) Bent or damaged components.
Repair or replace.
b) Arm lifter (cueing
ees
control) does not lift
3) Improper lift adjustment.
Inspect for damaged or missing parts. Repair, replace
arm:
|
and relubricate as necessary.
Nos. 1, 2, and 3.
c) Insufficient or
excessive lift:
Nos. 1, 2, and 3.
Pick
lowerin
:
nection
:
Arm lowering mechanism damaged or
Inspect to determine cause of damage, replace parts as
binding.
required, Relubricate.
Abnormal Sound
1) Ground lead is not connected
Connect properly to the amplifiers ground terminal.
a) Excessive noise:
Nos. 1, 2,and 3.
2) Dust or dirt has collected
Clean the stylus tip with a soft brush.
on the stylus tip.
b) Sound ts distorted.
Nos. 2, 3, 4 and 5.
3) Dust or dirt has collected on the
Clean the record with a good quality cleaner.
record.
c) Intermittent sound:
4) Stylus is worn.
Replace with new stylus.
Nos. 2,3, 4, and7
5) Amplifier tone controls set too high.
Set tone controls to lower position.
d) No sound:
Nos. 7,and 8.
6) Record is scratched or warped.
Replace record.
7) Phono cables are not connected
properly.
8) Amplifier is not being operated
Read the operating instructions that come with
properly (Function tape monitor
your amplifier.
switch, speaker switches, etc. are
not set correctly)
Advertisement
Table of Contents
