Use - Powerfix Profi PUTK 50 A1 Operating Instructions Manual

Folding load carrier
Hide thumbs Also See for PUTK 50 A1:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 3

Use

Undo the elastic fastening bungee and unfold the product until it audibly
clicks into place (see fig . 1) .
Press the knob on the handle and pull the telescopic bar out until it clicks
into place (see fig . 2) .
Do not stretch the fastening bungee more than the maximum usable
length of 130 cm . Keep your eyes, face and unprotected body parts
out of range of a possible springback .
NOTE
The fastening bungee must be under tension to ensure that the load is
held in place . Observe the size of the load .
Never apply a load of more than 50 kg .
Place a load onto the load area . Do not stack multiple loads .
Place the load centrally on the load area .
Secure the load with the fastening bungee (see fig . 3) .
Make sure that the fastening bungee is sufficiently tightened so that the load
is firmly held in place .
Also make sure that the fastening bungee is sufficiently tightened even for
small loads (see fig . 4) . The arrow symbol
bungee can be hooked on .
Move the product by pulling it behind you on both wheels .
1
4 
GB │ IE │ NI
WARNING! RISK OF INJURY!
shows where the fastening
2
PUTK 50 A1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PUTK 50 A1 and is the answer not in the manual?

This manual is also suitable for:

304510

Table of Contents