Advertisement
Alfred Z-Wave 700 Module
Please read this quick start guide carefully for correct and effective use. Failure to follow the recommendations set forth by
Alfred Inc. may be dangerous or cause a violation of the law. The manufacturer, importer, distributor, and/or reseller will not
be held responsible for any loss or damage resulting from not following any instruction in this guide. The product is intended for
indoor use in dry locations only. Do not use in damp, moist, and /or wet locations.
Available in selected Z-Wave Plus devices built upon 500 series technology and all devices built upon 700 series technology,
SmartStart lets you setup Z-Wave devices in seconds. Using SmartStart enabled apps, simply scan the QR code on any
1. How to add your Alfred Lock into a Z-wave network
1. Install the Alfred Z-Wave Module into the back of your Lock by removing the battery cover
and inserting the module in the designated slot on the lock
2. Follow the user guide of your 3
3. Prepare Alfred Lock for pairing with Z-Wave Hub
1) Enter master mode on your Alfred Lock (** + Master PIN Code + √)
2) Input "8" to enter "Network settings"
3) Input "1" to enter "Inclusion mode"
2. How to remove your Alfred Lock from a Z-wave network
1. Follow the user guide of your 3
2. Prepare Alfred Lock for Unpairing with Z-Wave Hub
1) Enter master mode on your Alfred lock (** + Master PIN Code + √)
2) Input "8" to enter "Network settings"
3) Input "2" to enter "Exclusion mode"
Quick Start Guide
(ZW2-PRO)
Important Safety Information
What is SmartStart
compatible app to connect it to your Z-Wave gateway.
rd
party hub to enter inclusion mode.
rd
party hub to enter exclusion mode.
www.Alfredinc.com
support@alfredinc.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Alfred ZW2-PRO
- Page 1 Please read this quick start guide carefully for correct and effective use. Failure to follow the recommendations set forth by Alfred Inc. may be dangerous or cause a violation of the law. The manufacturer, importer, distributor, and/or reseller will not be held responsible for any loss or damage resulting from not following any instruction in this guide.
- Page 2 2. Please use this procedure only when the networks primary controller is missing or otherwise inoperable. 3. After factory reset the default master pin code on the Alfred lock will be “12345678”, please modify it after reset (Refer to Alfred programming instruction guide for your lock model).
Need help?
Do you have a question about the ZW2-PRO and is the answer not in the manual?
Questions and answers