HP marten-mouse-free Instructions For Use Manual page 16

General notes
If your vehicle has already been attacked by martens, the animals have
most probably left scent-marks to mark their territory. These scents must
be removed before mounting the marten shocker device, since other
martens may enter the engine compartment even when it is protected.
The best way to do this is to have the engine washed thoroughly. Besides
this, the animals often leave scent-marks under the vehicle, e.g. on the
parking space. It is therefore recommended to remove these marks with
a brush and detergent so that the marten does not have any reason to
defend its territory. On account of the electrical control circuit, the LED
control lamp may glow brighter or dimmer. This has no effects
whatsoever on the function.
Technical data
Supply voltage:
Medial power input:
Power consumption:
Miniature fuse:
Acoustic pressure:
Sound frequency:
Sound on duration:
sound off duration:
Number of high voltage plates:
Plate voltage:
High voltage dissipation time
(when device is switched off):
Waterproof:
Safety instructions
Important: Damage caused by not adhering to the operating instructions
is not covered by guarantee. HP-AUTOZUBEHHÖR accepts no liability
whatsoever for any resulting consequent damages.
- Only operate the device at its intended voltage.
- In case of repairs, only use original spare parts, to avoid serious
damage.
12 V DC
30 mA
0,42 W
1 A external
approx. 85 dB
approx. 12 – 24
kHz +/- 10%
approx. 22 secs
+/- 4 secs
approx. 22 secs
+/- 4 secs
4 x 2 pieces
(plus/minus)
400 V DC +/- 50 V
DC
max. 60 secs
IP65