Advertisement
Quick Links
Advertisement
Summary of Contents for Ofs Tilly
- Page 1 Tilly assembly instructions...
- Page 2 Tilly assembly instructions Table of contents Safety instructions Light features Freestanding base installation Clamp mount installation Surface mount installation Assembly instructions ofs.com imagine a place® 800.521.5381...
-
Page 3: Important Safety Instructions
Tilly assembly instructions Important safety instructions When using an electrical furnishing, basic precautions should always be followed, including the following: This furnishing is made for commercial use only. Read all instructions before using this furnishing: DANGER To reduce the risk of electrical shock: 1. -
Page 4: Light Features
Tilly assembly instructions Light features Occupancy sensor The under-head integrated Passive Infrared (PIR) occupancy sensor automatically turns the fi xture off after 30 minutes of no detection. Coverage: 360° lens view, 90° outward detection angle, coverage of 30° diameter at 15” distance. - Page 5 Tilly assembly instructions Freestanding base Assembly: Remove fi xture from packaging. Stand fi xture upright. Connect silver quick-connect cord to power supply. (Figure A) Figure A Assembly instructions ofs.com imagine a place® 800.521.5381...
- Page 6 Tilly assembly instructions Clamp mount Assembly: Turn the adjustment screw out to allow for a space larger than the thickness of the work surface. Position the clamp bracket onto the work surface in the desired location and tighten the adjustment screw. Make sure there is a gap between the back edge of the surface and the wall or panel of approximately ½”...
-
Page 7: Surface Mount
Tilly assembly instructions Surface mount Tools required: 2-⅛ “ Diameter hole saw Phillips head screwdriver Assembly: Drill a 2-⅛ ” hole in the work surface. Install surface mount base in hole, ensuring anti-rotation stop is located appropriately for the intended orientation.