OPERATION
Ballast User Interface
ALLEGRA-C™ ballast provides control over the intensity,
colour temperature, green/magenta bias, hue and saturation,
x y coordinates, RGB, and a range of other parameters for
precision control.
Control is via the local user interface on the front of the ballast,
DMX, or Wireless connection.
In all modes, the
will show the current state of:
status bar
DMX Base Address
DMX Personality
DMX Control Source
(int, ext, LTP)
Control priority
(when local control is locked)
'LOCKED'
(when fixture is cycling through a demo)
'DEMO'
Factory Reset
Factory reset and clearing all memory presets is achieved by holding down the bottom left and bottom right buttons together
while cycling the power.
Lock Mode
The local controls can be locked and unlocked by holding down the bottom left button for 2 seconds. 'LOCKED' will be shown
top centre of the display when local control is disabled.
To release LOCKED status and DEMO status, hold down bottom left button.
PANALUX ALLEGRA-C USER MANUAL
(wired, wireless, local)
WARNING. ALL STORED PRESETS WILL BE ERASED.
In white mode (shown above), the display will always show:
(percentage)
Dim Position
CCT
Green/Magenta Bias
18
ISSUE 1.0 | OCTOBER 2023