Spectravideo SVI-605 User Manual page 33

12. Service and Trouble Shooting
We hope you don't have problems but just in
case ... see if you can solve them by using the
table below. If you can't, they try to determine
which component in your system is at fault,
and bring it into a store for repair.
Problem
Probable
Causes/Solutions
SVI-605 won't function 1.Expander power is
Power Indicator 'OFF'. Check the
'OFF'
connection and the
power switch.
2.Fuse may be blown.
Replaced only with a
fuse of the same
rating.
SVI-605 won't function 1 .Improper connection
Power Indicator Check the wiring of
'ON' all interface cable to
interface cartridge.
2.Bad system bus
connection..
Adjust and refix the
SVI-318/328MKII to
SVI-605.
Floppy drive no 1 .Check power supply
function to floppy drive.
2. Check 'Daisy Chain'
interface cable
position, jumper of
select drive and
terminator.
3. Check and swap
disk media.
Disk Drive B won't 1.Improper connection
function
of the cable to the
disk drive. Plug the
connector of the disk
drive controller cable
firmly to the edge
connector of the disk
drive
B.
2.Wrong insertion of
the disk drive
assignment
selection plug.
The plug should be
inserted to the DS1
pin socket of drive B.
Printer no function
1. Paper is jammed
remove and reload
the paper.
2. Check printer
interface to printer.
Printed characters
are too light or
smudging
1 .Improper printer
pressure, adjust the
lever's position on
the print head.
2.Wrong ribbon setting
reset the ribbon
3.Old or worn-out
ribbon
Replace the ribbon.
29 30