WIRING DIAGRAM The video signal from the camera is transferred to the monitor via the 6m video extension cable that will need to be run through the boot, the passenger compartment and under the dash to connect to the monitor. At the back of the car, the reversing tail lamp powers the camera.
Page 4
WIRING DIAGRAM continued.. Power Harness Reversing Camera Female Female Power connector (Red) (Yellow / Video Signal) Male Male Power connector (Yellow / Video Signal) (Black) Video adapter cable Green wire Connects to reversing lamp (Trigger) 12V + Power connector Positive wire connects to reversing lamp (Trigger) Male 3.5mm jack...
INSTALLATION NOTE: To prevent potential electrical shorts, it is essential to disconnect the ( - ) negative battery cable before installing the product. Mount the camera. When mounting, ensure that the camera does not cover any part of the license plate. Choose a position that won’t prevent you from accessing the boot release or tailgate latch.
Page 6
INSTALLATION continued... Connect the BLACK wire of the trigger cable to chassis or negative of lamp. Connect the BLACK plug from the trigger cable to the RED socket from the camera. Connect the YELLOW RCA socket from the camera to the YELLOW RCA plug from the 6m video extension cable.
Page 7
Thank you for your purchase! Laser Corporation is 100% Australian owned & operated. To get the most out of your product please read the user manual carefully and keep for future use. For specific information relating to your product such as Spare Parts, FAQs, Warranty claims, and...
Page 8
Visit our website www.laserco.com.au Check us out at www.youtube.com/lasercoau...