Table of Contents
Advertisement
Reference Notes
CAUTION 1: Locking Tabs (L-1) and (L-2) are fragile.
Be careful not to break them.
1-1. Connect the wall plug to an AC outlet and press
the OPEN/CLOSE button to open the Tray.
1-2. Remove the Tray Panel by releasing two Locking
Tabs (L-1).
1-3. Press the OPEN/CLOSE button again to close
the Tray.
1-4. Press the POWER button to turn the power off.
1-5. Unplug an AC cord.
1-6. Release four Locking Tabs (L-2).
CAUTION 2: Electrostatic breakdown of the laser
diode in the optical system block may occur as a
potential difference caused by electrostatic charge
accumulated on cloth, human body etc., during
unpacking or repair work.
To avoid damage of pickup follow next procedures.
2-1. Slide out the pickup unit as shown in Fig. D6.
2-3. Short the three short lands of FPC cable with sol-
der before removing the FFC cable (CN201) from
it. If you disconnect the FFC cable (CN201), the
laser diode of pickup will be destroyed. (Fig. D6)
CAUTION 3: When reassembling, confirm the FFC
cable (CN201) is connected completely. Then remove
the solder from the three short lands of FPC cable.
(Fig. D6)
[2] Tray Panel
(L-1)
(S-1)
(S-2)
[3] Front
Foot(L)
[5] Rear
(S-4)
Foot(L)
(S-6)
(L-2)
(S-7)
[8] Bracket(L)
[10] Bottom Case
1-6-2
[1] Top Case
(S-1)
(S-1)
(S-1)
(S-5)
[4] Front
[6] Rear
Foot(R)
Foot(R)
(S-3)
Fig. D1
[7] DVD Unit
(S-6)
(S-8)
[9] Bracket(R)
Fig. D2
E5790DC
(S-1)
Advertisement
Table of Contents
