GE OPAL P4INSASBVTS Owner's Manual page 9

Care and Cleaning
System Descaling / Sanitizing Procedure
(continued)
6. Descaling
or use the Opal Cleaning Kit and follow the instructions
provided.
Sanitizing
and then adding one teaspoon of bleach.
7. Plug in Opal and hold the Clean button for 3 seconds to
NOTE: Water will begin circulating and the Cleaning
confirm the unit is now in the cleaning process. After three
minutes, the water will stop, the Cleaning indicator light will
maker is not interacted with for 5 minutes, the pulsing will
state.
Descaling: run the clean cycle up to 3 times, with the
and soak. While the unit is soaking, dip a cloth in the
solution and wipe the inner walls. Use a cotton swab to
clean any cracks. When you are done, rinse the cloth
with clean water and wipe Opal again to remove any
scale deposits.
Sanitizing: Once the Cleaning indicator turns off,
promptly drain the Opal.
pressing the Clean button to initiate a second cleaning
cycle. Once the cleaning cycle has completed, drain the
unit of all water.
reservoir each time (you may continue to repeat the rinse
three seconds.
Opal.
12. When complete, fill the reservoir with fresh water and press
49-9000060 Rev. 0
water reservoir
Making Ice Add Water Clean Defrosting
Clean Power
Hold 3 Sec
Clean Power
Hold 3 Se