Driving The Machine - Toro GrandStand 18560 Operator's Manual

Driving the Machine

Important:
Back the machine over curbs, 1 wheel
at a time; driving it forward over curbs could
damage the machine.
CAUTION
Positioning one lever too far in front of the
other causes the machine to spin very rapidly.
As a result, you may lose control of the
machine, causing personal injury to you and
damage to the machine.
Slow down the machine before making sharp
turns.
1. Move the motion-control levers down to the
center, unlocked position.
Figure 27
1. Front reference bar
2. Left control lever
3. Rear reference bar
2. Slowly push the motion-control levers forward or
rearward. Move 1 lever farther than the other
lever to turn.
Note:
The farther you move the motion-control
levers, the faster the machine moves in that
direction.
3. To stop, pull the motion-control levers back to
the N position.
EUTRAL
g330778
4. Right control lever
5. Right control lever in the
P position
ARK
6. Left control lever in the
P position
ARK
22
Figure 28
g385716