Table of Contents
Advertisement
I
DA-01
KKH CERa
Safety precautions
J.
Handling a disc
3
7
• To obtain maximum performance and life expectancy
from this appliance, read the 'Safety Instructions' packed
with the unit.
•
perate the unit only on 1 20 volt 60 Hz AC power
source.
• Route the power supply cord so that it is not likely to
be damaged or walked on.
• We recommend that during extended periods of non
use that the appliance power cord be unplugged from the
outlet.
• Care should be taken so that objects do not fall and
liquids are not spilled into the enclosure through openings.
• Install the unit so that its location or position does not
interfere with its proper ventilation; for example, the unit
should not be used on a rug or similar surface that may
block the ventilation openings, or placed in a built-in
installation that may impede the flow of air through the
ventilation openings
• Locate this unit on a firm shelf or table or other device
which will provide a firm stable and horizontal position
To handle a disc use
only one of the two
manners exhibited.
Although built to withstand a certain amount of the
effects from dusts, soils and scratches, discs should be
treated with the care normally accorded to conventional
analog records. Always protect a disc against scratches,
soils and dusts, etc. We recommend that during non-use
• The digital signals on the disc are read by a laser through
an optical lens on which moisture may condense if the
player is moved from a cold place to a warm one or if the
heater has just been turned on. If moisture does condense
on the lens, it is likely that the player will not function
properly. In this case, we suggest that you turn the power
switch on and leave the player for about an hour or so with
the disc removed to evaporate any moisture. If problems
still exists, then see your nearest service dealer.
• Before using the player, be sure that the shipping screws
and all other transportation hardware are removed from the
bottom panel. Retain them for future use in case shipping
becomes necessary.
period of discs that they should be retained in the original
case. If a disc is treated with reasonable care, the only
maintenance likely to be needed to maintain the excellent
sound reproduction is the cleaning as indicated below.
To wipe the disc surface, use only soft cloth.
Do not use benzine or thinner which will
damage the surface.
Note. Do not touch
on the side having
the program, which is
the side opposite the
label side.
C7
,
0*
Advertisement
Table of Contents
