Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Tool Shed TSWH5
- Page 1 AUTO DARKENING WELDING HELMET WITH PAPR SYSTEM TSWH5 www.thetoolshed.co.nz...
-
Page 2: Table Of Contents
TABLE OF CONTENTS PRODUCT DETAILS Product Details ToolShed Auto Darkening Welding Product Model Helmet with PAPR Specifications Product Identification Product Code TSWH5 Safety Guidelines PAPR Assembly PAPR Operation Helmet Operation PAPR Cleaning & Storage Helmet Maintenance & Storage DISTRIBUTED BY: PAPR Troubleshooting... -
Page 3: Specifications
OPERATION MANUAL OPERATION MANUAL SPECIFICATIONS PRODUCT IDENTIFICATION PAPR System Low Speed: 150 LPM Air Flow High Speed: 180 LPM Filter Assembly Consisting of Foam Pre-Filter Standard Air Filter & HEPA Filter Operation Temperature -5°C – 55°C Storage Temperature -10°C – 50°C Storage Humidity ≤90% R.H. -
Page 4: Safety Guidelines
OPERATION MANUAL OPERATION MANUAL SAFETY GUIDELINES SAFETY GUIDELINES Electrical Safety anything else that could be of risk, away from WARNING WARNING moving parts in the machine, or they could be • DO NOT use the power tool or machinery caught therein. in raining conditions or wet areas where READ ALL SAFETY WARNINGS &... - Page 5 OPERATION MANUAL OPERATION MANUAL SAFETY GUIDELINES SAFETY GUIDELINES • Welding Helmet Specific Safety Read and understand the Material Safety Data rator when there is danger of fire or explosion. WARNING • Sheets and the manufacturers instructions for Do not use the powered air purifying respi- •...
-
Page 6: Papr Assembly
OPERATION MANUAL OPERATION MANUAL SAFETY GUIDELINES PAPR ASSEMBLY Charging the Battery Installing the Air Filter not remove the respirator until outside the contaminated area. • • Remove the battery from the blower assembly. Install the HEPA filter into the blow body. •... -
Page 7: Papr Operation
OPERATION MANUAL OPERATION MANUAL PAPR ASSEMBLY PAPR OPERATION Attaching the Breathing Tube to Attaching the Breathing Tube to Operating the Controls Battery Light Indicator the Blower the Hood • Green Light: High Battery level between • • Insert breathing tube Terminal 2 into blower Insert breathing tube Terminal 1 into the 90–100% •... - Page 8 OPERATION MANUAL OPERATION MANUAL PAPR OPERATION PAPR OPERATION • Battery; Verify the battery is fully charged and Putting on the Respirator securely connected to the blower assembly. • Place the blower assembly against lower back • Air Flow; Test air flow according to related with breathing tube extending upwards.
-
Page 9: Helmet Operation
OPERATION MANUAL OPERATION MANUAL HELMET OPERATION HELMET OPERATION Shade Guide Table Sensitivity Control Adjusting the Helmet • • When welding ceases, the viewing window Adjust the headgear diameter with the twist automatically changes from dark back to light, knob on the back. The knob is locked until but with a pre-set delay to compensate. -
Page 10: Papr Cleaning & Storage
OPERATION MANUAL OPERATION MANUAL PAPR CLEANING & STORAGE HELMET MAINTENANCE & STORAGE Cleaning Storage Maintenance Cleaning • • • • Front Cover Lens Replacement: Replace Detach the battery pack, breathing tube, and If the blower will not be used for an extended Keep the sensors, solar cell, and filter lens the blower. -
Page 11: Papr Troubleshooting
OPERATION MANUAL OPERATION MANUAL PAPR TROUBLESHOOTING HELMET TROUBLESHOOTING FAULT POSSIBLE SOLUTION FAULT POSSIBLE CAUSE SUGGESTED SOLUTION Press ON/OFF to start blower. Cover lens dirty Clean or replace cover lens. Difficulty Viewing Recharge battery. Through Filter Filter lens dirty Clean filter lens. Blower Does Not Supply Air To Hood Verify battery is properly connect to blower.
Need help?
Do you have a question about the TSWH5 and is the answer not in the manual?
Questions and answers