Clock Setting.7; Quick Min Function.7 - Panasonic NN-S751 Operating Instructions Manual

Clock Setting
The oven will operate without setting the clock.
Example: To set 11:25 a.m. or p.m.
1.
• Press once.
►Colon flashes.
2.
□□00
• Enter time of day using the
number pads.
►Time appears on the
Display Window,
colon continues flashing.
3.
• Press.
►Colon stops flashing;
time of day is entered.
NOTES:
1.To reset the clock, repeat steps 1- 3.
2 The clock will retain the time of day as long
as the oven is plugged in and electricity is
supplied.
S.CIock is a 12 hour display,
4.0ven will not operate while colon is flashing.
Quick Min Function
This feature allows you to set and/or add cook¬
ing times easily in multiples of one minute.
To Set Cooking Time:
1.
Quick
Min
•
Set cooking time
(up to 10) Power Level
is P10.
2.
Start
• Press Sfart Pad.
►Cooking begins and
Display Window
counts down.
At the end of cooking, 5
beeps sound and colon
or time of day appears.
NOTE:
1 .You can use other power levels, select desired
power level before setting cooking time.
2. After setting the time by
Quick Min
Pad, you
cannot use Number Pads, and vice versa.
3. Press
Quick Min
Pad to add more time during
cooking. To verify the additional cooking time,
check the
Display Window.
Power & Time Setting
How do t program Power and Time?
Example: To cook at P 6 (MEDIUM)
Power for 1 minute 30 seconds
1.
Pre5
Power
Level
nOLeveta
IS
5 ti mes.
• Select
Power Level.
(according to the chart
below)
000
• Set Cooking Time using
number pads.
3.
• Press.
►Cooking will start. The
time on the
Display
Window
will count
down.
Press Power Level
once
PIO(HIGH)
twice P9
3 times P8
4 limes P 7 (MEDIUM-HIGH)
5 times P 6 (MEDIUM)
6 times P5
7 times
P4
8 times
P 3 (MEDIUM-LOW)/DEFROST
9 times P2
10 times
P 1 (LOW)
NOTES:
1 .For more than one stage cooking, repeat steps
1 and 2 tor each stage of cooking before
pressing Start Pad. Maximum number of
stages for cooking is 5 stages.
2. When selecting P10 (HIGH) power for the first
stage, you may begin at step 2.
3. TWO beeps will sound between each stage of
programming. Five beeps will sound at the end
of the eniire sequence.
4. When selecting P10 (HIGH) power, the
maximum programmable time is 30 minutes.
For other power levels, the maximum time is
99 minutes and 99 seconds.
5. For reheating, use P10 (HIGH) for liquids,
P7 (MEDIUM-HIGH) for most foods and
P6 (MEDIUM) for dense foods.
e.For defrosting, use P3 (MEDIUM-LOW).
7