Table of Contents
Advertisement
3 ALIGNING THE CARTRIDGE
Slide the carrier into the slots in the clear
plastic eetting gauge. Take care that the stylus
{does not catch on the gauge as the cartridge
enters
The stylus tip must be vertically
above the point
lat which the lines on the gauge cross. If it Is
not, move the cartridge until it is correctly
aligned.
4 CONNECTING THE CARTRIDGE
When the alignment is satisfactory, tighten
both foxing scrows, remove tho gauge, ané cor
rect the insulated leads on the earner by push
ing their tage onto the cartridge output pine.
Use the following colour code in conjunction
with the cartridgo manufacturer' inetructione:
Rod — Right hand channel signal
Green ~ Right hand channel ground
White — Loft hand channel signal
Blue ~ Left hand channel ground
Note: if cartridge has only three pins or tags,
use the groen le
together. Insul
required
'and tuck away any lead not
Dagrom 11 Aig te Catcpe
5 REFITTING THE CARRIER
(2) Move the tonearm locking lever to FREE
'support the tonearm over the platter away
'rom the operating controls with one hand,
to avoid risk of damage to the cartridge.
(b) Locate the contact portion of the carrier
Ported by the head and protrude approxi:
mately Jin trom the front of the heed.
Gently push the carrier into the head. It
docs not mattor whother the cartridge
tilting lever (see diagram 18) Is at M or A
at this stage.
6 STYLUS FORCE AND TONEARI
ANTLSKATING DEVICE
Set these as instiucted in the following sec-
tions.
Diagram 2 Resting Carer
Advertisement
Table of Contents
