Advertisement
USER MANUAL UB3000-3P | 3000 LUMEN LED 3 PANEL UTILITY LIGHT
ADDITIONAL WARNINGS:
• DO NOT open the product. It is NOT possible to
change the LED lights or source.
• DO NOT use this product in small enclosures. It is
recommended for medium to large size rooms.
• Temperature rating is from -4
O
• This product is designed for dry/damp use and is
not waterproof. Never use near standing water.
• Although this product is simply screwed into a socket, it is important to
make sure no bare wires are exposed and that all wiring is insulated.
• This product is NOT to be used with dimmers. Dimmers can damage the
product and usage of one will void the warranty.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Warning: Changes
or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. Note: This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that the interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: (1) Reorient or relocate the
receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the
equipment into an outlet on a circuit different from that of the receiver. (4) Consult the dealer or an
experienced radio/TV technician for help.
If you have questions or are missing parts, please contact customer service at 1-888-745-4837
F to 104
F
O
TO AVOID ELECTRICAL SHOCK, MAKE SURE TO TURN
BW
OFF THE MAIN POWER SOURCE OR DISCONNECT POWER
USER MANUAL UB3000-3P | 3000 LUMEN LED 3 PANEL UTILITY LIGHT
STAMP
INSTALLATION INSTRUCTIONS:
1. Before installing, make sure to shut the power OFF at the circuit breaker.
It is highly recommended that a surge protector is installed.
If Ballast is present, it must be bypassed.
2. Remove the existing bulb by unscrewing in a counter-clockwise
direction.
3. In a clockwise direction, screw in the unit. Do not overtighten as this
may cause damage to the light and/or the socket. It may be necessary
to pivot each light panel down before screwing in the unit.
4. Turn the power ON at the circuit breaker.
5. Turn the light switch ON. The LEDs will illuminate.
6. There are 3 adjustable light panels. Pivot each one to meet the desired
light in the area. To protect your eyes, never look directly into the LED
lights even when adjusting the panels.
If you have questions or are missing parts, please contact customer service at 1-888-745-4837
WARNING:
RISK OF ELECTRICAL SHOCK.
DURING THE INSTALLATION OR SERVICE
OF THIS PRODUCT
Advertisement
