Dreo DR-HFV001 - 550W Cordless Vacuum Cleaner Quick Start Guide

ASSEMBLING YOUR VACUUM CLEANER

Assembly

For normal operation, all accessories must be attached securely.

Assembly for cleaning ceilings, floors and corners:

Assembly for cleaning furniture surfaces:

Assembly for cleaning in a flexible way:

CHARGING YOUR VACUUM CLEANER

Installing the Battery

To install, slide the battery into the slot in the back of the main body.

Tip: To remove, press and hold the Battery Release Button then slide out the battery.

When battery level is below 20%, the vacuum will switch to Turbo mode automatically.

Charging

Fully charge your new vacuum before first use. You can connect to charger either directly or on the dock.

Charging Directly

Flip open the charging cap on the main body and charge directly.

Charging on the Dock

1. Find an ideal height between 50 and 60 inches (125 and 150 cm). Apply the sticker on the wall and drill through the holes, then install the plastic anchors.
   
2. Align the holes in the docking station with the anchors and drill the screws into place.
   
3. Connect the charger into the charging port at the bottom of the station.
   
4. Rest the vacuum cleaner and accessories onto the docking station.
   

• 
  Install on concrete load-bearing walls only.
• Do not drill into any damp walls like bathroom and kitchen walls.

USING YOUR VACUUM CLEANER

Do not use to suck up water or other liquids.

CLEANING AND MAINTENANCE

Dustbin

Keep the dust below the MAX fill line. Using your vacuum when dust is above the MAX fill line may cause malfunction.

1. Hold the main body in a downwards position.
2. Pull the dustbin cover as shown to dump the dust out.
   

HEPA Filter

Clean the filter regularly for blockages. It is recommended to replace the filter every 3 months or when the icon alerts on the LED display.

1. Rotate the filter lid counterclockwise and pull out the filter unit.
   
2. Hold the filter while rotating the lid to separate filter and lid.
   
3. Wash and dry up completely before installing them back into place.
   

Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave or near a naked flame.

Cyclone Assembly

1. Hold the cyclone assembly and rotate to release it from the main body.
2. Wash and dry up completely before installing it back into place.
   

Do not wash the main body.

Brushroll

1. Slide the tab on the underside of the floor brush head to pop up brushroll.
2. Remove blockages on the brushroll and near the suction mouth.
3. Wash the brushroll with cold water and dry up completely.
4. Insert the brushroll back and make sure it clicks in place.
   

• 
  Check the brushroll if the headlights on the brush head won't come on.
• Wash the brushroll only.

Do not wash the floor/carpet brush head.

GENTLE REMINDER

Check the appliance regularly and contact us if it shows any of the following signs:

• Power cord or plug is damaged.
• Loud noise, unusual smell or excessive heat.

Scan the QR code below or search "Dreo House Cleaning" to join our Facebook group. Our online engineers are always ready to solve any product problems you may experience.

Looking for help?

(888) 520-3736
Mon - Fri, 9:00 am-5:00 pm PST/PDT
support@dreo.com
www.dreo.com