Table of Contents
Advertisement
ing products.
products off and connect the cable.
Notes:
© To interrupt data transfer, press
4. Select the mode on the transmitter and receiver.
SCHEDULE
(Transmitter)
SCHEDULE]
(Receiver)
2. Select the data transfer function on the receiver.
UNIT TO UNIT
SEND
RECEIVE
VERIFY
3, Select the receiver in the receive mode.
2
UNIT TO UNIT
RECEIVING
MODE
|
UNIT TO UNIT
SEND
RECEIVE
VERIFY
and press[2nd] [OPTION ] .
ES
ZQ-3250
5, Perform data transfer.
|
Notes:
® |f the mode of the transmitter and the mode of the receiver are not
the same, data transfer is not established. The message "DATA
ERROR"* is displayed.
When telephone directory data are transferred, directories on the
transmitter and receiver can be different. However, the contents
received by the receiver will be stored in the open directory. For
example, if data transfer is established between file TEL1
in the
transmitter and file TELS in the receiver, then the contents of TEL1
will be sent to and stored in TELS.
*® Tur
off the secret function on both the transmitter and the
receiver before mode transfer.
®
If the amount of memory available on the receiver at the time of
transfer is insufficient, data transfer is not possible. The message
"MEMORY FULL" appears. Delete any unnecessary data, verify
whether the available memory is sufficient, and repeat the data
transfer procedure.
Transferring backup data
All the contents of the Organizer are transferred. During backup data
transfer, data stored on the receiver are deleted. Proceed with cau-
tion.
(Backup data transfer is only possible between identical products.)
1. Select the data transfer function on the receiver and set it in the
receive mode for backup data transfer.
2
,
UNIT TO UNIT
BACKUP
RECEIVING
MODE
2. Select the data transfer function on the transmitter and perform
backup data transfer.
1Y
Verifying data
It is possible to verify data by mode or by data item. If any discrepan-
cies are found, the message "VERIFY ERROR" is displayed.
Verify data in the SCHEDULE mode.
1. Select the mode on the transmitter and the receiver.
SCHEDULE
(Transmitter)
SCHEDULE]
(Receiver)
2. Set the receiver in the verify mode.
OPTION]
3
UNIT TO UNIT
-VERIFYING-
3. Select the data transfer function on the transmitter.
Note: To verify one data item, display the data item to be verified and
press
[2nd] [OPTION] -
4. Perform verification.
1
Advertisement
Table of Contents
