Aquavx Pro Quick Start Manual
  1. Manuals
  2. Brands
  3. Aquavx Manuals
  4. Measuring Instruments
  5. Pro
  6. Quick start manual

Aquavx Pro Quick Start Manual

Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

Quick Start Guide
Aquavx Pro™

1. Remove the Front Plate

1.
Remove the front plate of the Aquavx Pro by unfastening the four screws located at each corner of the
panel.
2.
The front plate is connected via 2 bulkhead connectors and an earth ground connection on the bottom-
left of the plate. Removing these connections during install will allow more mobility inside the unit.
•
Detach the earth ground connection by unfastening the nut to the bottom left of the plate.
•
Optionally, detach the bulkhead connectors by lifting the lock and pulling the connector.
Earth Ground
Connection
(Unfastened)
Nimble: 9M01-3200-A001 | EN-2024-01-V1
Bulkhead Connectors
(lock mechanism
circled)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pro and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Aquavx Pro

  • Page 1 Aquavx Pro™ 1. Remove the Front Plate Remove the front plate of the Aquavx Pro by unfastening the four screws located at each corner of the panel. The front plate is connected via 2 bulkhead connectors and an earth ground connection on the bottom- left of the plate.
  • Page 2 Quick Start Guide Aquavx Pro™ 2. Wire Your Aquavx Pro Drill holes in the unit enclosure for the power feed and the amount of I/O wiring required. Affix the necessary conduit fittings and assure proper waterproofing. Entry points are physically labeled on the outside of your unit upon delivery.
  • Page 3 Quick Start Guide Aquavx Pro™ I/O Connection Quick Reference Guide Figure 1 Configuration Sheets and Manuals Are Available at Cattron.com Nimble: 9M01-3200-A001 | EN-2024-01-V1...
  • Page 4 If your system is preconfigured, the I/O will arrive programmed per the configuration sheet you provided to us. If it is not preconfigured or if changes are required, the Aquavx Pro can be programmed via a locally connected PC, remotely over the cellular network, or the controller on the unit. Programming instructions can be found in the manual.
  • Page 5 Quick Start Guide Aquavx Pro™ Wired Aquavx Pro Note: For satellite modem installations, connect modem directly via the external cable. Configuration Sheets and Manuals Are Available at Cattron.com Nimble: 9M01-3200-A001 | EN-2024-01-V1...

Table of Contents