Buffalo CK164 Instruction Manual page 5

Before assembly, ensure to:
• Switch off and disconnect the appliance from
the power supply.
• Clean all cutting discs and parts that come
into contact with food with warm soapy water.
For details, refer to section "Cleaning, care &
maintenance".
• Never immerse the motor base in water, nor
rinse it under running water.
Mounting the cutting disc and feed chute attachments
1. Place the bowl onto the motor shaft, then turn anti-clockwise to lock into place.
2. Place the disc stem onto the shaft, then add the slicing/grating disc (side marked with 'UP' facing
upward).
3. Place the feed chute lid on the bowl, resting its left end then right end using the locking tab on the
bowl.
4. Insert the pressing plate and food pusher.
Tips:
• Choose desired cutting disc according to food type and desired food shape to achieve.
• Pre-cut food into smaller pieces according to the diameter of feed tube.
• Only use provided pusher to push food down when in use and feed gradually.
• If large quantity of food needs to process, divide into several batches.
Mounting the S blade and flat lid attachments
1. Mount the bowl as instructed above. Then locate the S blade onto the shaft (Ensure to remove the
plastic protective sleeve first).
2. Put food in, then secure the flat lid.
3. Insert the lid plug, which can be used to add ingredients during operation.
CK164_ML_A5_v1_20230724.indb 5 CK164_ML_A5_v1_20230724.indb 5
Warning:
BUFFALO accept no responsibility for
property damage or personal injury caused
by incorrect assembly/disassembly.
Cutting blades are sharp! Handle with care!
Equipped with a safety interlock system,
the appliance will not start before the parts
are securely mounted.
EN
5
2023/7/24 17:19 2023/7/24 17:19