Advertisement
For USA: Use a UL listed cordset consisting of a minimum 18AWG, type SVT or
SJT three conductor cord, a maximum of 15 feet in length, and a parallel blade,
grounding type attachment plug rated 15A, 260 VAC.
For Europe: Use a cord consisting of a minimum (18 AWG) H05-VVF cord and
grounding type attachment plug rated 16A, 250 VAC. The cordset should have
the appropriate safety approvals for the country in which the equipment will be
installed and should be marked HAR.
5.
Parallel port connector, to be used for connecting to an external
parallel printer. This is optional.
HARDWARE INSTALLATION
When you have unpacked the drive and the parallel printer port
cable, and the suitable mains cable (optional: please consult your
dealer), then follow next steps:
See figure page 6 for overview of a configuration.
1.
Place the drive near your computer.
2.
Use the parallel printer port cable to connect your drive to your
computer: put one end of the cable onto the drive (see figure of
REAR VIEW page 4, connector 2) and connect the other end of
the cable to the parallel (printer) port of your computer.
NOTE: If you have a printer already connected to the printer
port, then remove the printer cable from your computer and plug
this cable into the CDD3615 CD-Recorder drive (see figure of
REAR VIEW page 4, connector 5).
3.
Connect the mains cable between your drive (see figure of
REAR VIEW page 4) and the mains AC wallplug.
NOTE: the drive will operate on any mains AC voltage, ranging
from 100 to 240 Volt.
5
Advertisement
