Advertisement
Assembly
Main components
The drywall lift is shipped as several components that must be assembled before use:
•
Frame assembly
•
frame assembly, including a lever assembly and telescoping unit
•
cradle assembly, without its detachable crossarms
•
two cradle crossarm assemblies
Use
To lift, turn the turning wheel clockwise. Insert the locking bolts into the corresponding holes to secure
the traverse.
To lower the traverse, proceed as follows:
1.
Keep the wheel with the left hand. Turn the wheel slightly counter-clockwise and at the same
time slide the brake handle upwards to unlock the brake.
Warning!
The traverse will lower automatically after you have let go the brake. Keep the turning
wheel well to allow the traverse to lower safely.
2. To lower the traverse completely, remove the locking bolt.
3. Secure the panel with the help of the hook at the end of the traverse.
4. Before lifting, insert the locking bolt into the corresponding holes.
https://www.wiltec.de
ATTENTION:
•
Always wear a hard heat and protective goggles.
•
Max. lifting charge: 68 kg
•
Never exceed the max. lifting charge.
•
A damaged, worn, or improperly mounted cable
may cause severe injuries or damages. Check
cable before each use. Immediately replace a
damaged cable.
•
Only one drywall panel can be lifted onto the lift
at once.
•
Store all components of the drywall lift in a dry
environment.
•
Thoroughly read the instructions for use before
operating the drywall panel lift.
Item 64206
Page 4
06 2023-1
Advertisement
