Do you have a question about the VCT2640 and is the answer not in the manual?
Questions and answers
Issabelle Evans
January 29, 2025
replace light
1 comments:
Mr. Anderson
May 14, 2025
To replace the light in a Victor VCT2640 calculator, follow these steps:
1. Power Off: Turn off the calculator and unplug it from the power source.
2. Access the Light Area: - Locate the printer cover on the calculator (usually near the paper roll area). - Gently remove the printer cover by lifting it up or sliding it off.
3. Locate the Light Bulb: - Find the small light bulb near the printer mechanism. This is typically used to illuminate the print area.
4. Remove the Old Bulb: - Carefully grasp the old bulb. - Pull it straight out from the socket. If it’s stuck, gently wiggle it to loosen.
5. Install the New Bulb: - Insert the new bulb of the same type and rating into the socket. - Ensure it is seated firmly but do not force it.
6. Reassemble: - Replace the printer cover. - Plug the calculator back in and turn it on to test the new light.
Note: Use only the recommended replacement bulb type to avoid damage. If unsure, check the owner’s manual or contact the manufacturer.
Need help?
Do you have a question about the VCT2640 and is the answer not in the manual?
Questions and answers
replace light
To replace the light in a Victor VCT2640 calculator, follow these steps:
1. Power Off: Turn off the calculator and unplug it from the power source.
2. Access the Light Area:
- Locate the printer cover on the calculator (usually near the paper roll area).
- Gently remove the printer cover by lifting it up or sliding it off.
3. Locate the Light Bulb:
- Find the small light bulb near the printer mechanism. This is typically used to illuminate the print area.
4. Remove the Old Bulb:
- Carefully grasp the old bulb.
- Pull it straight out from the socket. If it’s stuck, gently wiggle it to loosen.
5. Install the New Bulb:
- Insert the new bulb of the same type and rating into the socket.
- Ensure it is seated firmly but do not force it.
6. Reassemble:
- Replace the printer cover.
- Plug the calculator back in and turn it on to test the new light.
Note: Use only the recommended replacement bulb type to avoid damage. If unsure, check the owner’s manual or contact the manufacturer.
This answer is automatically generated