Advertisement
El Control®
60PS/f
Pendant Subwoof er
with Crossover
Professional
Series
Key Features:
►
High impact, 150 Watt
direct
radiati
ng
pendant
subwoofer with
built-in passive
crossover for
up to
four satellite speakers.
►
200
mm
(8
in) long-excursion
driver.
►
8 ohm (150 Watt) and 70V/100V (100
Watt)
operation.
►
Hanging hardware
with 4.5
m
05
foot)
galvanized steel cable and easy
to
adjust
clamp.
►
Stylish
design,
available
in black
or
white (-WH).
►
UL listed (speaker and
hanging
cable
system).
Applications:
The
Control
60PS/
T pendant
subwoofer
loudspeaker provides
bass extension
and high
impact
for
high-fidelity
sound systems
in
a
wide variety of applications
including
restaurants,
retail
stores,
music
cafes,
hea lth
clubs,
theme
bars,
leisure
venues, and other
locations
where
full-range high fidelity
foreground/
background music
systems are
utilized.
Featuring
150 Watt power handling
and
low distortion, the long-excursion 200 nun
(8
in) low frequency driver
features
butyl
rubber
surround
for
well-damped,
tight
sound
quality
and
long-term reliability,
and a
polypropylene-coated
cone for
humidity
protection. The high-temperature
50
mm
(2
in)
voice coil and
low-mass fiberglass
coil former
ensure good
bass transient response
and
excellent stability
under high power, high duty-
cycle, working conditions.
The
Control
60PS/
T may be driven by itself
(or with other subwoofers) on an amplifier
channel, sending
it
either a signal
that has
been
actively
low-passed
earlier
in the
signal
chain via
DSP
or a
full-range
signal,
utilizing
the built-in passive 125 Hz low-pass filter. The
included passive
crossover also
provides high-
passed
satellite outputs for
use
with either
two
or four satellite
loudspeakers
(not
for
one
or
three
satellite speakers),
resulting in
a
full-
range, wide-bandwidth,
passively-crossed,
mono
subwoofer-satellite
system.
Using
the
built-in
passive
crossover
is best
suited
for
satellite speakers with sensitivities
in the 82 dB
to 86
dB
(2.83V
@
lm)
range,
resu lting in
a
well-balanced overall
frequency response.
A 100 Watt multi-tap,
wide-bandwidth, low-
saturation
transformer
allows
the
speaker
to be
used
on either a
70V/
100V distributed
speaker
system or as a
direct low-impedance
8!1
speaker.
If
satellite speakers are
used
on
the
70V
/
lO0V
settings,
the
satellite speakers should
be
low-impedance
(8!1
to 16!1
each).
A
loop
out connector
is provided
on
the
subwoofer for
looping the full-range input
signal
to
other loudspeakers or
to
other
subwoofer/
satellite systems.
Rubber boot
covers
for
each
locking
connector
protect the
terminals
and
the
optional
MTC-PC60 full-top
cover accessory adds additional
termina
l
protection for when
using
outdoors.
Specifications:
System:
Tran
sducer:
Enclosure:
Frequency
Range
(-10
dB)',
42
Hz
- 350
Hz
Frequency
Response(±
3
dB)',
55
Hz
-
125
Hz
Power
Capacity
2
:
300 Watts Continuous
Program Power, 100 hrs
150
Watts Continuous
Pink
Noise,
100 hrs
Nominal Sensitivity
(2.83V/
1m), 88 dB
Rated
Maximum SPL,
107 dB @
I
m (3.3 ft) average, 113 dB
peak
Rated Impedance:
8 ohms
Transformer Taps,
IIOW, 55W,
30W
(&
15W@70V).
Set via
rotary
tap-selector switch
(70V/
100V
taps along with direct Sfl setting) on top
terminal
panel
Transformer
Insertion Lossc
0.98 dB@
15W,
0.99 dB@
30W,
0.94 dB@
55W,
1.10@ 110W
Standalone
Hookup:
Connect
to Input
connector;
built-in
low-pass
filter
permanently engaged.
Loop
Out
in
parallel with
Input
connector (pre
low-pass
filter) for
sending to additional speakers.
Subwoofer-Satellite
Hookup:
For
either
two or four satellite speakers (not for one or
three
satel
li
te
speakers). With
two
satellite
speakers,
must
connect
to Sat
1
and Sat 2
terminals
only (NC to Sat 3 and Sat 4 terminals). Satellite outputs
high-
passed. Suggested satellite speakers
include
Control 62P
(pendant),
Control
52 (surface-mount on-wall) and Control 42C (in-ceiling). Satellite
speakers
to
be low-Z type (8
to 16!1) regardless
whether tap selector is
set
to
low-Z or
70V/
100V. Loop
Om in parallel with Input connector (pre
low-pass
filter)
for
sending
lO
additional speakers.
Enclosure Material:
Gri lle,
Environmental:
Termination:
Suspension:
Safety
Agency,
200mm (8 in) polypropylene-coated
paper
cone with
butyl
rubber
surround,
50
mm
(2 in) high-temperature copper voice
coil,
vented
fiberglass
resin
voice coil former.
High
impact polystyrene
Zinc-plated steel grille with powder-coat finish
,
foam backing (grille and
grille
backing
are
removable
for
painting)
Exceeds
Mil
Spec 810 for
humidity,
salt spray,
temperature
& UV.
IP44
capability
per !EC
529 - splash-proof rating
Six
removab
le locking 2-pin connectors with screw-down
terminals.
Input, Loop
Out,
Sat
1,
Sat
2,
Sat
3,
Sat 4. Max wire 12
AWG
(2.5 mm').
Rubber terminal
covers included.
Two
identical suspension cable systems (one as main suspension cable
and
the
other as safety
cable),
each consisting of 4.5 m (15 ft) long, 2
mm
(0.077
in) high-tensile
galvanized-steel wire rope suspension cable
with spring-clips for clipping onto the
loudspeaker
bracket and GrippJeTM
brand
adjustable-height
cable fasteners for infinitely adjustable
height.
Cable
has
SWL rating of 45 kg (99
lb).
Speaker
listed per
UL1480
(UEAY),
transformer registered per UL1876.
In
accordance with
1EC60849/
EN60849. Suspension system
and
Gripple•-
brand
cable
fastener listed per
ULl 598 and UL2239, TUY, and CSA Class
3426-01 & Class 3426-81.
Dimensions, 333
mm
(13.1
in)
diameter, 344
mm
(13.6
in) height to top
of cabinet.
369 mm
(14.5
in) to
top
of suspension bracket.
Net Wei ht
7.6 k
(16.7
lb)
Shipping
Weight
17.6 kg
(38.7
lbs)
per
pair-packed
carton
Included Accessories:
Two suspension cable systems (see "suspension
\ above),
six
removable
locking 2-pin euro-block
connectors, six rubber cover boots
for
euro-
block
connectors.
Optional Accessories:
MTC-PC60 full top
panel
/
terminal
cover. Wire access
holes in plastic
cover
to
be
drilled
by
installer
to suit
the number
and
dimensions
of
wire.
Colors,
Available
in
black or white (-WH). Paintable.
'
Full-space
(suspended)
z
Continuous Pink Noise rating is
!EC-shaped pink noise
with a 6 dB crest factor for
100 hours
continuously. Continuous
Program
power
is
conservative expression of
the
system's ability
to handle normal
speech and
music
program
material,
and
is
defined as 3
dB
above
the
Continuous
Pink
Noise
Rating.
JBL
continually engages
in research re
lated to
product improvement.
Changes
introduced into
existing products without
notice are an expression of that
philosophy.
Advertisement
Table of Contents
Need help?
Do you have a question about the JBL PROFESSIONAL Control 60PS/T and is the answer not in the manual?
Questions and answers