Installation - Yamaha CR-840 Owner's Manual

AM RECEPTION
First set the TUNER FM/AM switch to AM, and
set the tuning indicator to the desired station
frequency. Adjust the tuning knob to give the
maximum SIGNAL meter reading. Note that the
FM TUNING meter does not function for AM
stations.
Your Yamaha Loop Antenna is a special, low-noise
antenna for AM broadcasts. Always be sure to
connect it to your receiver. Otherwise, AM
broadcasts may not received.
If the FM antenna is used for an AM antenna,
install the combination bar as in Fig. 9.
INSTALLATION
1. Installation position
This antenna can be mounted to the re^r panel
of a receiver, rear of a rack, or on a wall. Install
it as far away from noise sources as possible.
2. Installation method
Peel the seal off the rear of the antenna holder,
position the adhesive side of the holder at the
position you wish to install it, and push the
holder against the panel, wall, or rack firmly.
Note: Since the adhesive is extremely strong,
be sure to position the holder correctly
before mounting it securely.
The loop antenna can be detached from the
holder and reinstalled by either of the two
methods illustrated in the Fig. 8. Use the
method which provides the best reception.
Fig. 8