Advertisement
Installation & Operating Instructions
IMPORTANT ELECTRICAL
Electrical Contractors please Note: FIBROPOOL Pumps must be plugged into a dedicated, GFCI
protected circuit.
Pump Must Be:
Level and on a solid base, such as a block, to keep the accumulated rain water from flooding the motor.
Use the shortest available pipe/ hose.
Install gate valve in front of the pump.
Be protected from excess moisture.
Have at least 12 inches all around for ventilation.
Pump must be installed at a level LOWER than the pool water.
NOTICE:
Pump suction and discharge connections have moulded in thread stops, Do not try to screw pipe in
beyond these stops.
ABG Series Pool Pump
INSTALLATION
Only qualified persons should install this pump
Advertisement
Table of Contents
Summary of Contents for FibroPool ABG Series
- Page 1 INSTALLATION Only qualified persons should install this pump IMPORTANT ELECTRICAL Electrical Contractors please Note: FIBROPOOL Pumps must be plugged into a dedicated, GFCI protected circuit. Pump Must Be: Level and on a solid base, such as a block, to keep the accumulated rain water from flooding the motor.
- Page 2 ROUTINE MAINTENANCE There are 2 routine maintenance needed for your Fibropool® ABG Pump. ** Clean the basket. Debris or trash that collects in basket, will choke off water flow through the pump. Follow...
- Page 3 SERVICE & REPAIR PARTS Refer all service inquiries to FIBROPOOL CO LLC Fibropool is an American Company, based in USA . Your pump is assembled in the State of Mississippi, USA, from domestic and foreign components You can Contact us via email: support@fibropool.com, or via our web service at www.fibropool.com...
- Page 4 Lid Assembly ABG 004 Lid Oring ABG 014 Basket ABG 003 Pump Body ABG 001 Union Core ABG 005 Union Nut ABG 007 Union O ring ABG 016 Drain Cap ABG 018 Drain Cap Gasket ABG 017 Diffuser O ring ABG 015 Diffuser ABG 006...
Need help?
Do you have a question about the ABG Series and is the answer not in the manual?
Questions and answers