Advertisement
3
APPLYING THE REAR SPOILER TO THE CAR
Line up the spoiler in position. Make sure that the corners of the spoiler have a
nice even gap to the front and especially to the sides. Make sure you can still
reach the detached protective film of the tape.
EVO-1 REAR SPOILER
FOR VW GOLF 7 & 7.5
Installation Manual
Now press the corners of the spoiler lightly against the car. Once again, make
sure that the gaps are even. You can now carefully pull out the protective film
of the tape from under the rear spoiler. Press the spoiler firmly against the
surface where the tape is placed.
You can now remove the protective film of the rear spoiler.
Note: The tape needs up to 24 hours to develop its full adhesive strength.
Installation is not recommended, especially in colder temperatures.
We wish you a lot of fun with your new spoiler!
Tuning is not just a passion, it's a lifestyle!
Enjoy it!
WWW.ZAERO-DESIGN.COM
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ZAERO DESIGN EVO-1
Summary of Contents for ZAERO DESIGN EVO-1
- Page 1 Line up the spoiler in position. Make sure that the corners of the spoiler have a nice even gap to the front and especially to the sides. Make sure you can still reach the detached protective film of the tape. EVO-1 REAR SPOILER FOR VW GOLF 7 & 7.5 Installation Manual Now press the corners of the spoiler lightly against the car.
- Page 2 EVO-1 REAR SPOILER Tape application on the inside of the rear spoiler: FOR VW GOLF 7 & 7.5 TEST FITTING Make a test fitting by placing the spoiler on the roof edge of the car. Take a close look at where the tape makes contact between the spoiler and the car.
Need help?
Do you have a question about the EVO-1 and is the answer not in the manual?
Questions and answers