Summary of Contents for Boyel Living BL-TV01-BK
- Page 1 TV Stand BL-TV01-BK BL-TV01-WH mportant – Please read these instructions fully before starting assembly Web：www.boyelliving.com Service Contact : service@boyelliving.com Phone Number: (951) 213-4743/(323)982-8955 Issue 1 -01/08/2023...
-
Page 3: Part List
ASSEMBLY INSTRUCTIONS Part List： Part List： ITEM DESCRIPTION PART ITEM DESCRIPTION PART Bottom panel Top panel Fireplace fixing Bottom support panel Left central upright Right central Central support upright Left side Door Right side Shelf Backboard... -
Page 4: Hardware List
ASSEMBLY INSTRUCTIONS Hardware List： ITEM DESCRIPTION PART 7*43mm Male Camlock Female Camlock 8*30mm Dowel 3.5*14mm Screw 5*40mm Screw 4*14mm Screw 6*10mm Bolt Hex Key 6*30mm Bolt 3*16mm Back Panel Stiffener Hinge Adjustable Support Cap Handle Shelf Support Wall Strap Fireplace Support... - Page 5 DO NOT OVER TIGHTEN. NE PAS SERRER EXCESSIVEMENT. Adjusting Hinges Hinge adjustment: a: To move the door up or down, loosen screws shown and move top panel to suit b.To move the door in or out, loosen screws shown and move top panel to suit. Retighten screws C:To move the door left or right, adjust screws...
- Page 6 C x 24 E x 2...
- Page 7 E x 4 E x 4...
- Page 8 CAM-LOCK Tighten until shoulder is flush with panel.Do not overtighten Shoulder A x 8 or undertighten(see example below) NO GAP Panel Panel...
- Page 9 B x 8...
- Page 10 J x 8 G x 8 H x 1 Screw all blots but do not tighten them at once (just mount them in position temporarily)
- Page 11 H x 1 I x 12 Screw all blots but do not tighten them at once (just mount them in position temporarily), then tighten them eventually. F x 8 L x 2...
- Page 12 D x 8 D x 8...
- Page 13 N x 8 P x 2 Before attaching fireplace to TV stand, unscrew four silver screws on the both sides of fireplace.
- Page 14 Carefully remove the front glass, and place it on a soft and clean surface. F x 4 Insert the fireplace to the stand and secure it with screw (Q).
- Page 15 Attach the glass front to the fireplace. Fix the tempered glass with 4pcs of 4x10mm screws.