Advertisement
SxA
two-way systems are perfect for use as powered floor monitors.
The correct projection angle is already incorporated into the enclosure design of the
SxA2oQ,
Simply turn the
SxA2dO
on its side and operate the system in the same manner as described
above. The F2(K) adapters are necessary to convert the .SxAlOO into a monitor and are
shipped with the speaker. To install the adapters, simply insert them into the speaker (See
Figure 8 below). The F200 adapters can be easily removed by pulling in the opposite
direction.
The F2()() Monitor Foot kit contains twm> plastic feet.
The F200 is used with any 12-inch
Sx
or
SxA
speaker enclosures.
Fnsert the feet firmly into the holes in the rear cabinet (See Figure S).
Plemove the F2(}() monitor feet by pulling in the opposite direction.
FIGURE 8:
installing the F200 Monitor Fool on Sx/MOO Speaker
CAUTIOIsl: The F200 monitor feet protrude from the enclosure. Care should be taken
when moving the enclosure, since damage to the feet or enclosure might occur If the
system Is dropped or slid across a rough surface. It Is recommended that the feet foe
removed for transport.
11
ELECTRO-VOiCE'^ Owner's Manual
Advertisement
