Page 2
1. Power on: open the power supply knife of the machine cable. After power on, all display units will light up once and the buzzer will drop once. Power button: each furnace area has an independent power button. When you want to start one of the burners, press the power button to turn on the power and enter the standby state.
Page 3
5. Firepower adjustment: in heating mode, push the regulator, the digital gear from 1 9. Panel high temperature warning: there is still residual temperature on the furnace to 9 is normal heating gear, and the P gear is rapid heating. After 3 minutes, it will panel after use, warning display H, be careful of scalding hands.
Page 4
SAFETY PRECAUTIONS This product does not consider the following: Warning: If the surface is cracked, turn off the appliance to avoid possible electric shock. Use of equipment by unattended young children and disabled children's play equipment. 01. Do not overheat an empty pan. 02.
Page 6
HEAT DISSIPATION STRUCTURE INSTALLATION DRAWING When the machine is embedded, to ensure the normal use of the machine and better heat dissipation. Requirements: 1. 30-50mm heat dissipation should be left on the left and right sides and behind. 2. The counter interior should be as large as possible to ensure that enough cold air is sucked into the machine.
Page 7
POWER SUPPLY INSTALLATION DRAWING Electrical diagram of the beautiful line (black, white, green E) Electrical diagram of the beautiful line (black, white, green E) This figure is only for three-phase power in the United States, and the voltage This chart is only applicable to 220 V single-phase power countries in between two live lines is 240VAC Europe and China Three core cable machine connection drawing...
Need help?
Do you have a question about the K5001 and is the answer not in the manual?
Questions and answers