Advertisement
Quick Links
Windcrest
SA1000 Autodialler System
(Can be used to upgrade an AD1000EN-1R)
Mains
Battery Backed
Phone Line or GSM
Power Supply
Windcrest
PRESS BUTTON FOR
3 SECONDS, IF
UNOBTAINABLE,
PRESS BUTTON
AGAIN.
Lift Car
Tel: 0208 795 0333
Windcrest
Fax: 0208 795 0444
Page 1/5
Advertisement
Summary of Contents for Wind Crest SA1000
- Page 1 Windcrest SA1000 Autodialler System (Can be used to upgrade an AD1000EN-1R) Mains Battery Backed Phone Line or GSM Power Supply Windcrest PRESS BUTTON FOR 3 SECONDS, IF UNOBTAINABLE, PRESS BUTTON AGAIN. Lift Car Tel: 0208 795 0333 Windcrest Fax: 0208 795 0444...
- Page 2 NB: The Power supply unit has been designed to supply power only for the Autodialler and no extra power is available for additional equipment. Over loading may damage the power supply. Tel: 0208 795 0333 Windcrest Fax: 0208 795 0444 SA1000 System with built in Push button Page 2/5...
- Page 3 2. Orange & 7. Brown/White. Note:- The RJ45 Cable is supplied with the unit. However, if any other RJ45 cable to be used for the SA1000 unit, the plug must be made as per the above drawing. Incorrectly made plug will result in damaging of the unit and will violate warranty terms.
-
Page 4: Programming Via Keypad
Programming Via Keypad Press *1234# on the keypad (on back of the unit) and the unit will give two bleeps to confirm it is in the programming mode. Following are the programming parameters strings. At the end of each string, the unit will announce the complete string to confirm the programmed parameter. - Page 5 Remote Programming of the SA1000 unit The autodialler has the facility to auto-answer an incoming call, after 6-15 seconds. Once the call has been answered, the programming mode can be instigated by a series of simple commands via a simple Touch-Tone Telephone or a Mobile Phone.
Need help?
Do you have a question about the SA1000 and is the answer not in the manual?
Questions and answers