Pioneer PD-Z84M Service Manual page 5

NOTES:
© Parts without part number cannot be supplied.
-@
The A mark found on some component parts indicates the importance of the safety
factor of the part. Therefore,
when replacing, be sure to use parts of identical
. designation.
ioe
: :
This classification shall be adjusted by each distributor because it depends on model
number, temperature, humidity, etc.
©
Parts marked by "@" are not always kept in stock.
Their delivery time may be
longer than usual or they may be unavailable.
2.3 PACKING
PD-Z970M type only
LINE VOLTAGE SELECTION
Line voltage.can be changed with the following steps.
1. Disconnect the AC power cord.
2. Remove 'the . bonnet.
3. Change the position of the jumper @ as follows.
(Refer to the Mother board assembly.)
4. Stick. the line voltage label-on the rear panel.
Part. No. Description
AAX- 193 220V label
AAX- 192 240V label
SIGE
MOTHER BOARD ASSEMBLY
10