Initial Operation - Janser 135SH Operating Manual

C O L U M B U S
G r i n d i n g m a c h i n e s a n d a c c e s s o r i e s
4 INSTRUCTIONS
4.1

Initial Operation

Assembling the guide bar
a. First of all the guide bar has to be fitted to the body with the four fixing nuts
which have to be tightened with a 13 mm fork wrench.
b. Then plug the cable of the guide bar on to the machine body.
c. Unlock the guide bar by pulling the lower lever on the right, tilt the machine
slightly forward into the upright position until it locks.
d. With a tipping chassis tilt the machine slightly forward and step on the wheel frame
until it locks.
4.2 Installing and changing accessories
Manual
a. Unplug the machine.
b. Tilt the machine back until the guide bar lies on the floor.
c. Install the accessory with a slight left-hand movement to the fixing device.
d. To remove it turn the same jerkily to the right.
by machine
a. Connect the main cable.
b. Put the accessory on the floor in front of the machine.
c. Tilt the guide bar into the convenient working position by pulling
the lower lever on the right and lock it.
d. Tilt the machine slightly back and move it over the accessory.
e. With a tipping chassis push the pedal of the wheel frame to move it up.
f. Switch on the machine shortly and the accessory locks in.
14
OPERATING INSTRUCTIONS